RADIO CONTROLLED KOAXIAL HELICOPTER RTF - Tamiya

Free flying training• When you feel secure, stand laterally to the model andpractice control from this angle of view or• Allow the model to fly toward you and control it in theopposite direction• Avoid jerky load variation. since otherwise the upper andlower rotor could touch and cause the model to crash.• Always fly the model in front of you or allow it to circle aboveyou. If you allow the model to fly behind your back, youcould lose your orientation and thereby the control over thehelicopter.Never attempt to catch the model in midflight!GBi. How to change frequenciesMake sure that nobody else is transmitting in the proximity ofyour frequency! Interfering signals on the same frequency canmake you lose control over your model. If you are flying withother RC users, it might be necessary to change the frequency.TransmitterA rapid change of frequencies is possible simply by unpluggingan interchangeable crystal on the back of the transmitter andthen plugging in another one.For reasons of operational safety, employ only crystals recommendedby the suppliers explicitly for use in your remotecontrol system.Remove the holder for the transmitter crystal from the back ofthe transmitter housing of a switched-off transmitter.Set the crystal replacement with another channel of the samefrequency band. Pay attention that the correct crystal isemployed. Transmitter crystals are as a rule characterized withthe letters T or TX (T = Transmitter).ReceiverPlug in an interchangeable crystal into the receiver for a rapidchange of frequencies.The suitable receiver crystal with the frequency suitable to thetransmitter must be labelled with the same channel number asthe transmitter crystal. It additionally bears the identificationletter R or RX (R = Receiver).Now take the transmitter and subsequently the receiver intooperation and check the functioning of the equipment.Do not mix up the transmitter andreceiver crystals!The transmitter and receiver crystals must be of an identicalfrequency.Make sure that the crystal is fully inserted in the transmitter andreceiver, not partially.j. Tuning tipTo make your helicopter more agile in the air, simply mount thesteering linkage in the outer hole of the servo lever as shownon the picture.CARSON Helikopter EC-135 Rescue 50 050 703121