how to read connector layout diagram

8A-1-8 HOW TO USE THIS MANUALHOW TO READ CONNECTOR LAYOUT DIAGRAMWhen necessary to know the location of an electrical part or an intermediate connector, it is easily possible toretrieve it by this diagram.First consult “SYSTEM CIRCUIT DIAGRAM” section or connector table at the right hand pages of this section forthe questioned connector code. Second refer to the diagrams of this section and look for the same code.More information on use of the code is illustrated below.Connector codeL 0 1Connector No (serial No : 01)Harness symbol (Refer to the table below)Harness symbol and corresponding harness nameA : Battery cableK : Room light harnessB : A/C harnessK : Spot light wireC : Engine harnessK : Roof wireD : Injector harnessL : Floor harnessE : Main harnessM : Rear bumper wireE : Oil pressure switch wireO : Back door harnessE : Console wireO : License plate wireG : Instrument panel harnessO : High mounted stop light wireJ : Front door wire Q : Air bag harnessJ : Rear door wire Q : Pretensioner wireJ : Rear joint wire R : Fuel pump wireThis indicates the ground point No.The same No. is used as the ground point. (For thedetails, refer to "GROUND POINT" section)}This indicates the connector code.The connector code in the parentheses ( ) has the samemeaning as the above intermediate connector and at thesame time, it indicates that there is a harness continuitybetween pages or illustrations in CONNECTOR LAYOUTDIAGRAM section. That is, it suggests that the harnessis continued to the other page or illustration and thecontinued harness can be identified by the same connectorcode.