TLS-401 TLS-403 Turbo - Soler & Palau

maged, it should only be replacedin one of our Repair Workshopsor by qualified staff in orderto avoid a dangerous situation.- Inflammable objects must not beleft within 50 cm of the hot aircircuit (curtains, etc.).- If the convector is installed permanently,the minimum distancesindicated in Fig. 1 must berespected.- On no account must any switch/ button be accessible by peoplein the shower or in the bathtub.- Whenever it is installed permanently,the convector must besituated so that the plug is accessible.WARNING!! Before starting theconvector, ensure that the base isfitted correctly.- Always keep the air inlet andoutlet grilles clean. Make surethe convector is disconnectedwhen cleaning is carried out.- Do not place the convector nextto a wall made of combustiblematerials (wood, plastic, etc.).- This appliance is not intendedfor use by persons, includingchildren, with reduced physical,sensory or mental capabilities,or lack of experience andknowledge, unless they havebeen given supervision or instructionconcerning use of theappliance by a person responsiblefor their safety.9- Children must be under watch toavoid that they could play withthe product.- This appliance must not be usedconnected to a programmer, timeror another device that controlsheater connection automatically.INSTALLATIONBefore starting the convector, thebase must be fitted or the devicemust be mounted on the wall.FITTING THE BASEFit the base supports to the sides(Fig. 3) and secure each one withthree screws. To remove the basesupports, loosen the screws and pullthe supports outwards.WALL MOUNTINGWall mounting is only possible whenthe base supports are not fitted.Once you have chosen the location,before fixing the convector to thewall, make sure that the minimumdistances are respected (Fig. 1).Proceed to mark and fix the upper supportsto the wall (Fig. 4, C). Once theconvector is mounted, immobilise itwith the lower support (Fig. 4, D and E).SWITCHING ON AND OPERATIONOnce you have checked that themains voltage coincides with thevoltage indicated on the name plate,connect the convector.