TLS-401 TLS-403 Turbo - Soler & Palau

1- Select the power using the powerselector (Fig. 2).2- To achieve a specific temperaturein the room, turn the thermostat control(Fig. 2) clockwise to the maximumposition.3- Once the room has reached thedesired temperature, turn the thermostatcontrol anticlockwise untilyou hear a slight click. When thethermostat control is in this position,the convector will connect and disconnectautomatically to keep thepre-selected temperature constant.Do not use this convector in roomswith areas of less than 4 m 2 . Donot place the convector in draughtyareas, as this could interfere withits correct operation. Do not use theconvector to dry clothes.ANTI-FREEZE PROTECTIONThe S&P convectors incorporate ananti-freeze device which triggers theconvector when the room temperaturedrops below +5ºC.To activate this device just connectthe convector to the mains, place thepower selector in any of the activepositions and the thermostat controlin the “*” position (Fig. 2).The convector will remain disconnecteduntil the room temperaturedrops below +5ºC when it will startautomatically to ensure the temperatureis maintained over +5ºC.This device is particularly useful inplaces where low temperatures are10common and the water pipes arelikely to freeze, etc.COMBINED OPERATION(TLS-403 Turbo)To accelerate the heating of the roomyou can also connect the fan by pressingthe fan switch. In this positionthe switch will light up.PROTECTION AGAINST OVERHEA-TINGIf any operating trouble is produced,the overheating disconnection systemwill automatically disconnectthe convector.If this occurs:-Place the power switch in the “0”position.-Disconnect the convector from themains.-Let the convector cool down for 15minutes.-Check that the air inlet and outletgrilles are not blocked. If necessary,clean them with a vacuum cleaner.-If the convector still does not worknormally after these checks, pleasecontact the extensive network ofS&P Official Services.MAINTENANCEThe S&P convectors do not requireany special maintenance. Before cleaningdo not forget to disconnect theconvector from the mains.Wait for the body to cool down and