Manuale utente_Owner's manual_Manuel d ... - Husqvarna

REPLACING THE NUMBER PLATE BULB- loosen screw (1) and remove the number plate bulb(2) from the mudguard;- take bulb holder (3) and bulb (4) out of the support;- pull the bulb (4) to detach it from bulb holder.Once the bulb has been replaced, reverse the above procedureto reassemble.HEADLIGHT ADJUSTMENTWhen checking the proper aiming of the headlight beam:inflate tyres at the right pressure, have a person sitastride the motorcycle and set the motorcycle perpendicularto its longitudinal axisIn front of a wall or a screen positioned at a distance of10 metres (32.8 ft), draw a horizontal line correspondingto headlight centre height, and a vertical line alignedwith vehicle longitudinal axis.Beam height can be adjusted as follows:- Regulate the setscrew (1) on the upper part of the lightunit;by tightening, the light beam is raised;by loosening, the light beam is lowered.EN2If possible, execute this operation in a shaded place.When the low beam is on, the upper edge between darkand lit zone should be at 9/10th of headlight centre fromground.1341SPECIFICATIONS - OPERATION - MAINTENANCE EN - 41