Manuale utente_Owner's manual_Manuel d ... - Husqvarna

CLUTCH CONTROLThe clutch control lever (1) is located on the left-handside of the handlebar.The position of the clutch control on the handlebar can beadjusted by loosening the retaining screws (2).WARNING*:After adjustment, turn the handlebaras far as possible to the left and makesure that the lever does not touch thebodywork.A "STOP" switch on the clutch lever support allows youto start the engine when the motorcycle is in gear or theclutch lever is pulled (the stand must be off the ground).CAUTION*:Do not forget to tighten the screws (2)after adjusting.REAR BRAKE CONTROLThe rear brake control (1) is placed on the right-handside of the motorcycle.A stop switch, during the braking action, causes the stoplight on the tail light to come on.GEAR SHIFT CONTROLThe lever (1) is placed on the left-hand side of the engine.The operator must release the lever after each gearchange to allow it to return to its central position. Neutralposition (N) is between the first and second gears.First gear is engaged by pushing the lever downwards;for other gears push it upwards.The position of the gear shift lever (1) on the shaft canbe varied. To do this, loosen the screw (2), pull the leverout and place the lever in a new position on the shaft.Tighten the screw once operation is completed.WARNING*: Do not push the lever toofar down!CAUTION*: Do not shift gears withoutdisengaging the clutch and closing thethrottle. The engine could be damagedby overspeed.WARNING*: Do not downshift whentravelling at a speed that would forcethe engine to overrev in the next lowergear, or cause the rear wheel to losegrip.EN1N4 53212112SPECIFICATIONS - OPERATION - MAINTENANCE EN - 19