You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SPBS10ShapeSurface B will be detected, but as surface A islocated outside the detection range, it maynever be detected.Road conditionsRough road conditions might trigger thewarning system.• Keep sensors clean at all times to ensure proper functioning.• Verify on a regular basis that sensors are still properly mounted.• Defective sensors should be replaced as soon as possible. Refer to an authorized dealer forspar parts.• It is strongly advised to test the system before use.8. Final TestsDetection TestPlace an obstacle of ± 1m high at 80 to 100cm behind the rear bumper of your vehicle. Turn theignition to ON and put the car in reverse. The system should start to beep automatically or displaythe distance to and the direction of the obstacle. Test the installed sensors individually.Warning TestPlace an obstacle of ±50 x 50cm at 80 to 100cm behind the rear bumper of your car. Turn theignition to ON and put the car in reverse. The system should start to beep automatically or displaythe distance to and the direction of the obstacle. Vary the distance of the obstacle to the vehicleby moving it forwards and backwards. The system should now beep at different intervals andmeanwhile display the distance to and the direction of the obstacle. Move the obstacle left andright: again, the system should beep automatically and display the distance to and the direction ofthe obstacle.9. Technical specificationsworking voltagerated voltagerated currentDimensionsLCD-housingLCDcontrol unitwarning modesdetection rangemax. alarm distance10-16VDC (via reversing light)12Vdc120mA85 x 53mm60 x 40mm98 x 70 x 25msound, distance+direction+bar graph on display0.3 - 2m2msensor angle H 60°, V 60°ultrasonic frequencyworking temperaturefor vehicle width up to 1.8m40KHz±1KHz-30°C to +70°C28.09.2009 8©<strong>Velleman</strong> nv
Change language