Aqua Jet Water Pressure Systems - Johnson Pump

EnglishThe wire connections must be sealedwith a marine sealant.Note: Before installation with electricalcontrol systems, check that equipmentto be used is of sufficient rated capacityto accept amperage draw of motor. Lowvoltage will cause motor to overheat.MaintenanceThe system shall be periodicallysanitized using the following procedure:1. Fill the tank with a solution of householdbleach and potable water –1 ml (.03 oz.) bleach/1 l (32 oz.)water.2. Open all faucets and run until waterflowing smells of bleach.3. Close all fauces.4. Drain solution from tank.5. Refill tank with potable water.6. Open all faucets and run untilbleach has been purged.Wiring dimensions(based on 3% voltage drop)WPS 2.9Wire sizeMax wirelenght* in m12 V 24 V1,5 mm² # 16 AWG 5 212,5 mm² # 14 AWG 8 344,0 mm² # 12 AWG 13 556,0 mm² # 10 AWG 19 82WPS 3.5Wire sizeMax wirelenght* in m12 V 24 V2,5 mm² # 14 AWG 5 214,0 mm² # 12 AWG 8 346,0 mm² # 10 AWG 13 5210 mm² # 6 AWG 19 82Wiring table–Max0.2 m+TerminalfuseSwitchRedWPS 4.0Wire sizeMax wirelenght* in m12 V 24 V2,5 mm² # 14 AWG 7 304,0 mm² # 12 AWG 11 496,0 mm² # 10 AWG 16 7310 mm² # 6 AWG 27 122BlackGreen/yellowPumpOther electrical devices, eg switch,circuit breaker, must be installedbetween the pump and the positive (+)lead on the battery (on the red wire).WPS 5.2Wire sizeMax wirelenght* in m12 V 24 V2,5 mm² # 14 AWG 5 224,0 mm² # 12 AWG 8 346,0 mm² # 10 AWG 12 5210 mm² # 6 AWG 20 8616 mm² # 4 AWG 31 138* The wire length is the total distance from the©battery to the pump and back to the battery.It is recommended to use a relay with a lightwire from main cable to switch to shorten themain leaders.10 Original instructions