F/FS 22-120 X/XS22-43

„E“ MACHINESTILTING THE MACHINE BACKWARDS TO SUFFICIENT POSITION FOR LOADING THE LINENThe machine can be tilted backwards to any position. Should it be required, the loading can be done in anyposition between 0° and 15° tilting angle. To tilt press „door opening“ - button (see fig.3.B pos.6) and„backward tilting“ - button (4) simultaneously. After cca 10s the machine starts tilting. Tilting can be interruptedif you release any of pressed button (see fig.3.B pos.4, 6). When the extreme position is reached, tilting isstopped automatically and pressing the buttons again will not influence the machine any more.LOADING THE LINEN INTO THE MACHINEFill the machine with linen by automatic loading. To lay the linen in the drum easily, use the function of thedrum tilting while loading the linen. For the drum rotating in tilted position press and hold the button for thedrum rotating in required direction (see fig.3.B. pos.1) or (2) and the button for the door opening (6) on thecontroller at the same time.4.4. CLOSING THE DOOR! WARNINGNEVER PUT FINGERS BETWEEN DOOR SEALING AND DRUM, AVOID POSSIBLE INJURY!Close the door carefully and secure it properly:„A“ MACHINES: By turning the handle up.„B“ MACHINES: By pushing the handle towards the machine.„C“ MACHINES: By closing the door forcefully, so that the lock latch snaps in.„D“ MACHINES + „E“ MACHINES: Lock-off mechanical bolt, close the door manually. The door issecured automatically.When you close the drum door manually, close it slowly, do not slam it quickly. Doing this youavoid the situation when the door bolt locks but the door bounces back and remains open.In such a case open the door temporarily (see „Installation and maintenance manual“).MACHINE EQUIPPED WITH AUTOMATIC DOOR CONTROL SYSTEM:Press and hold the button for closing the door (see fig.3.B. pos.5). The door will close completely and thedoor lock will be secured. Release the button (see fig.3.B. pos.5).You can only close the drum door when the machine is in the backward tilted position or aftertilting the machine back to basic position.When the door is closed in the forward tilted position, then for safety reasons it is not possible totilt the machine back to basic position or use other functions. Open the door temporarily, (see„Installation and maintenance manual“) and go on according to further procedure.TILTING THE MACHINE TO THE BASIC POSITIONFor tilting the machine to basic position press and hold the button for tilting (see fig.3.B. pos.3) and thebutton for the door opening (6) on the controller at the same time. If you release any of these pressedbuttons (see fig.3.B. pos.3, 6) the tilting will be interrupted. When the basic position is reached, the greenpilot light (see fig.3.B. pos.7) will light up on the programmer panel (7).Tilting the machine from the backward tilted position to the basic position is possible either withclosed or with open door. If the drum door was not closed in the backward tilted position afterloading the linen, close it.4.5. PROGRAM SELECTIONChoose one of the available wash programs, best corresponding to the quality of linen and allowed washtemperature in the wash load. Choose proper wash program with button PROGRAM SELECT on the controlpanel. There are various wash programs indicated on the control panel. Selection of the program determinestemperature and time for washing and rinsing. If you wish, it is possible to adapt the wash programs.(See programming manual).507 329 PUBLICATION DATE 05/05 USER´S MANUAL 11