D GB F NL I E

Detailed Information -Electrical Installation Set - Type 210 Saloon and Estate (T)22 3a/bFunction:black/green wire, right direction indicator lampblack/white wire, left direction indicator lamp– Lift the standard wiring harness out of the wiring duct in the left door sill.– Pull the black/green wire and the black/white wire out of the wiring harness.– Cut the black/green and black/white wires of the standard wiring harness and strip 10 mm of theinsulation on both sides of the cut– Solder the towing attachment wires to the ends of the wiring harness wires of the same colour andinsulate the connectionsCut jumper link at the relay between 86 and 87a and strip3aand tin 8-10 mm on both ends.Separate grey/green lead for rear fog light of standardwiring harness and insulate and tin-coat the ends aspreviously.– relay according to the circuit diagram and clip into thecable duct.– Solder wire from 86 to grey/green wire coming fromthe front.– Solder wire from 87a to the wire going to the rear.– Connect wire on 85 to the grey/green wire of the trailerwire set.b –Cutoff relay rear fog lamp3bX58 Socket for towing attachment, 13 pinN7 Light moduleE3 Vehicle lampIn vehicles equipped with the Parktronic system, solderthe brown/white wire of the towing attachment wiringharness to the standard wiring harness at point 2. Pullthe brown/white wire of the standard wiring harness outof the harness, cut it and strip 10 mm of the insulation onboth sides of the cut. Cut the wire of the towing attachmentwiring harness and strip 10 mm of the insulation on bothsides of the cut.Solder all the wire ends together and insulate the connection313 116 391 102 24/0221