LEDI® 1S LEDI® 1S VERSION NTP LEDI® 2S - Gorgy Timing

3. BRIGHTNESS CONTROLThe brightness is adjusted by pressing on the “+” and “-“ button.The button can be reached through the holes in the front of the unit, using a small screwdriver4. SETTING4.1. AUTONOMOUSThe time is set by using the “+”,”-“ and “PROG” buttons on the front of the unit.Each time the “PROG” button is used, a different part of the display begins to flash. This isthen modified by using the “+” and “-“ buttons.The setting cycle is as follows:►►Hour, minute, second display: adjustment of hours►►Hour, minute, second display: adjustment of minutes►►Hour, minute, second display: synchronisation►►Hour, minute, second display: time baseENGLISH4.2. AFNOR NFS 87500 CODE RECEIVERThe code is getting at right time when the code is connected on the «CODE» connector.4.3. SMPTE / EBU RECEIVER CODEClock used to read the time code SMPTE or EBU delivered at standard speed.►►Connect the code to the input terminal►►Automatic adaptation to SMPTE or EBU format►►Automatic selection at the rate of 24.25 or 30 images a second►►Maximum error tolerance for the rate of code received : +/- 10%►►Display freezes on last frame received if the signal emitter stops functioningMDE-LEDI1S-2S-1066V1.021