INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Cleaning the Shuttle Race<br />
This area must be kept free of dust, lint and<br />
occasional tangled thread. Clean the shuttle<br />
race area about every three months.<br />
y<br />
e<br />
• Cleaning the shuttle area<br />
q Bobbin case<br />
w Levers<br />
e Shuttle race cover<br />
r Shuttle<br />
t Shuttle race<br />
y Center pin on the shuttle<br />
w<br />
w<br />
1. Raise the needle bar to its highest point and<br />
remove the bobbin case q.<br />
2. Push shuttle race levers w aside. Lift shuttle<br />
race cover e and take shuttle r out.<br />
3. Clean the shuttle race t with a lint brush.<br />
4. Put a drop of oil on the center pin of the<br />
shuttle y and shuttle race t. Do not over oil.<br />
t<br />
r<br />
q<br />
• Replacing shuttle assembly<br />
w Levers<br />
e Shuttle race cover<br />
r Shuttle<br />
t Shuttle race<br />
y Center pin on the shuttle<br />
u Shuttle driver<br />
i Pointed hook<br />
o (Oil here)<br />
u<br />
w<br />
1. Turn handwheel so that shuttle driver u is<br />
forming half moon on the left side of the<br />
machine.<br />
2. Hold shuttle r by center pin y and position<br />
shuttle so as to form a half moon on the right<br />
side. The pointed hook will be on the bottom.<br />
3. Place shuttle race cover e into place over<br />
shuttle i assembly.<br />
4. Snap the levers w back into the original<br />
position.<br />
t<br />
w<br />
o<br />
i<br />
r<br />
y<br />
e<br />
54