INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
INSTRUCTION BOOK MANUAL DE INSTRUCCIONES ... - Janome
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
x<br />
v<br />
z<br />
Threading the Machine<br />
• Threading the machine<br />
* Raise the thread take-up lever to its highest<br />
position by turning the handwheel counter<br />
clockwise.<br />
* Raise the presser foot lifter.<br />
* Place a spool on the spool pin, with thread<br />
coming off as shown.<br />
z Pass the thread through the top cover thread<br />
guide.<br />
n<br />
c<br />
m<br />
b<br />
x Draw the end of thread around the upper<br />
thread guide.<br />
c While holding the thread near the spool, draw<br />
the end of the thread down around the check<br />
spring holder.<br />
v Firmly draw the thread up and from left to<br />
right over the take-up lever then down into<br />
the take-up lever eye.<br />
x<br />
c<br />
b Then down through the lower thread guides.<br />
n Slide the thread behind the needle bar thread<br />
guide on the left.<br />
m Thread the needle from front to back.<br />
v<br />
b n m<br />
z<br />
• Drawing up bobbin thread<br />
z Raise the presser foot. Hold the needle<br />
thread lightly with your left hand.<br />
x<br />
x Rotate the handwheel counterclockwise,<br />
toward you, for one complete turn. Bring the<br />
bobbin thread up by pulling the needle thread<br />
up.<br />
c<br />
c Pull both threads 4˝ to 6˝ (10.0 to 15.0 cm)<br />
under and behind the presser foot.<br />
20