INSTALLATION INSTRUCTIONS 30" (76.2 CM) GAS ... - Jenn-Air

4. Remove 4 locknuts on the motor side of the blower and
remove the bracket.
View from Motor Side of Blower
7. Remove the bracket from the other side of the blower motor,
rotate 90° and secure with 4 locknuts.
A
A. Electrical connector
5. Lift and rotate the motor 180° to reposition the electrical
connection.
8. Mount blower motor to floor using 4 - #8 x ¾" hex head
screws provided.
NOTE: Vent system will be connected after range has been
moved into its final location. See the “Connect Range to
Downdraft System” section.
A
B
Top View
C
A
A. 2⁷⁄₈" (7.3 cm) from back
wall to edge of bracket
B. Mounting bracket
C. Blower
A. Electrical connector
9. Go to the “Make Gas Connection” section.
6. Rotate bracket 90° and secure with 4 locknuts.
14