AXW smart - Biral

56
english
7. Settings
7.1 LED indication and pump function
Item
Description
1 Illuminated symbols: comfort level, operation in %
and type of error
2 Illuminated symbols: percentage and «operation/ ready»
1
2 3
4
961229_00
3 Illuminated symbols: pump fault
4 Control button
7.2 Normal operation
If no button is pressed for longer than 8 seconds, the display
changes to the normal operation status. The figure indicates
the proportion of pump running time to the total operating time.
7.3 Comfort setting
The pump changes to the «comfort setting» mode of operation
if the control button is pressed briefly.
The setting is changed every time the button is pressed:
C1
C2
C3
C4
C5
Maximum energy saving
Minimum pump running times (pump learns gradually,
very regular tappings necessary, responds above all
«on request»)
High energy saving
Short pump running time
Normal comfort (delivery condition)
Average pump running time
(sufficient for practically all cases)
High comfort
Normal pump running time
Maximum comfort
Increased pump running time
(pump gradually «forgets», also responds
with anticipation to tapping processes long past).
We recommend that the comfort setting should only be adjusted
to requirements after two weeks. If hot water is not supplied
immediately following the opening of a tapping point,
close the tapping point again and wait for circulation to start
(remote control function).
961260_00