MSAT 102-122-142-162-182-202-242

POSITIONING
The units are designed for outdoor installation.
• Check that the support surface can bear the weight of the unit (see weights and weight distribution on page 35) and that
both are level.
Place a layer of rubber between the base of the unit and the support (to prevent noise and vibrations).
• Respect the functional clearances.
• If the unit is installed on a balcony or on the roof, it should be placed on special antivibration mounts; in this case, the
connection tubing must be fitted with elastic joints.
• Position the unit so that the long sides are not facing prevailing wind.
• Anchor the unit to the ground.
FUNCTIONAL CLEARANCES
The choice of the location of the unit is of fundamental importance for correct operation.
Obstacles that block the flow of air (such as drains, hot air), difficulty in air circulation, leaves or other objects that may block
the exchanger coils, winds that contrast or excessively assist the air flow, can cause operating anomalies or shut-down the
machine.
The unit requires minimum spaces for operation and maintenance.
The following drawings show some types of installation; check on a case-by-case basis, keeping in mind the information
provided in this manual.
Note: The measurements are in mm
Free side
UNITS WITH INDEPENDENT CIRCUITS
UNITS WITH SEPARATE COMPRESSOR CONTROL
BASE ANTIVIBRATION MOUNTS
(accessory)
(accessory)
The units can be supplied upon request with separate compressor control,
fitted for connection to two distinct terminal units.
The power supply is still shared in common.
34