TNS400 - Toyota-tech.eu
TNS400 - Toyota-tech.eu TNS400 - Toyota-tech.eu
Muting the volume Press the [MUTE] button. To cancel muting, either press the [MUTE] button again or turn the [VOL] rotary knob to the right. While the audio system is muted, navigation voice guidance continues unmuted. Setting guide tone 1. Press the [FUNC/AF] button to establish the FUNCTION mode. 2. Press the [FUNC/AF] button until the indication on the sub display switches to BEEP. 3. Press the [SELECT (Right/Left)] button to switch between ON and OFF statuses for BEEP. Right : ON Left : OFF 4. Press the [ENTER] button. 4.4. Switching audio control modes The modes will switch one step in the order shown below each time the [ENTER] button is pressed. BASS → MID → TREB → BAL → FAD → LOUD → SVC → VOL → BASS → ... Turn the [VOL] rotary knob to the right or left in the audio mode while referring to the table below to adjust the sound. Mode Function [VOL] Rotary knob/Function BASS Adjusts bass level. Turn to the right Emphasizes low sounds. Turn to the left Softens low sounds. Emphasizes Turn to the right MID (MIDDLE) Adjusts middle level. mid-range sounds. Turn to the left Softens mid-range sounds. TREB (TREBLE) Adjusts treble level. Turn to the right Emphasizes high sounds. Turn to the left Softens high sounds. BAL (BALANCE) Adjusts left/right speaker Turn to the right Emphasizes right speakers. balance (BALANCE). Turn to the left Emphasizes left speakers. FAD (FADER) Adjusts front/rear speaker Turn to the right Emphasizes front speakers. balance (FADER). Turn to the left Emphasizes rear speakers. TNS400 15
Mode Function [VOL] Rotary knob/Function LOUD (LOUDNESS) SVC (Source Volume Control) Accentuates low and high frequencies when the volume is low. When loudness is ON, the apparent deficiency in the high sounds is compensated for. Sets the volume for each of the audio sources. (Except for FM) Turn to the right Turn to the left Turn to the right Turn to the left ON OFF Increases the SVC setting level Decreases the SVC setting level 4.5. Telephone muting function When you receive an incoming phone call, the volume of the audio function is reduced to zero. This function is effective when the car telephone is connected to the main unit with a cable. Upon receiving a telephone call, the sound muting function comes ON. When the mute function is ON, “TEL- MUTE” is displayed. When the telephone call ends, the mute function goes OFF and the volume setting in use immediately before the phone call was received is restored. Caution: While driving a vehicle, use a hands-free kit for phone calls to avoid danger. 4.6. Steering remote switch controls The compatibility of the main unit’s various modes and the steering remotes installed on your vehicle are as follows: Switch Name *1 Button operation Tuner CD MP3/ WMA Mode AUX iPod USB Power OFF PRESET < (TRACK) Press Press and hold CHANNEL UP SEEK UP TRACK UP FILE UP - TRACK UP FILE UP - FAST UP FOLDER UP - FAST UP FAST UP - < (TRACK) Press Press and hold PRESET CHANNEL DOWN SEEK DOWN TRACK DOWN FAST DOWN FILE DOWN FOLDER DOWN - - TRACK DOWN FAST DOWN FILE DOWN FAST DOWN - - 16 TNS400
- Page 1 and 2: TNS400 Owner’s manual Bedienungsa
- Page 3 and 4: © 2007 TOYOTA MOTOR CORPORATION Al
- Page 5 and 6: 6.4. Making and playing MP3/WMA fil
- Page 7 and 8: TNS400
- Page 9 and 10: 2. Safety precautions 2.1. Safety s
- Page 11 and 12: • Do not operate under abnormal c
- Page 13 and 14: 4. Names of controls and parts Fron
- Page 15: 4.1. Turning the power on and off W
- Page 19 and 20: 4.7. Switching between the audio an
- Page 21 and 22: 2. Remove the TomTom. Hold the TomT
- Page 23 and 24: 5. How to operate the tuner 5.1. Li
- Page 25 and 26: 3. Touch the preset switch where yo
- Page 27 and 28: 5.8. EON (Enhanced other network) I
- Page 29 and 30: • Do not use accessories (stabili
- Page 31 and 32: Media The media capable of playing
- Page 33 and 34: Converting CD music to MP3/WMA file
- Page 35 and 36: When a CD has been inserted Press t
- Page 37 and 38: 6.12. Scan tracks 1. Press the [FUN
- Page 39 and 40: 7. How to operate the USB music fil
- Page 41 and 42: Caution: • When using a USB exten
- Page 43 and 44: 3. Touch the name of the music file
- Page 45 and 46: 8.3. Fast forward/rewind Press the
- Page 47 and 48: You can search for a music file by
- Page 49 and 50: 10. Troubleshooting 10.1. If one of
- Page 51 and 52: If the following fail to solve the
- Page 53 and 54: 11. Technical data Power supply .2
- Page 55 and 56: 54 TNS400
- Page 57 and 58: 6.4. Erstellen und Wiedergabe von M
- Page 59 and 60: 58 TNS400
- Page 61 and 62: 2. Sicherheitshinweise 2.1. Sicherh
- Page 63 and 64: • Wenn alkalische Lösung von Tro
- Page 65 and 66: 4. Bezeichnung von Bedienungselemen
Muting the volume<br />
Press the [MUTE] button.<br />
To cancel muting, either press the [MUTE] button again or turn the [VOL] rotary knob to the right.<br />
While the audio system is muted, navigation voice guidance continues unmuted.<br />
Setting guide tone<br />
1. Press the [FUNC/AF] button to establish the FUNCTION mode.<br />
2. Press the [FUNC/AF] button until the indication on the sub display switches to BEEP.<br />
3. Press the [SELECT (Right/Left)] button to switch between ON and OFF statuses for BEEP.<br />
Right : ON<br />
Left : OFF<br />
4. Press the [ENTER] button.<br />
4.4. Switching audio control modes<br />
The modes will switch one step in the order shown below each time the [ENTER] button is<br />
pressed.<br />
BASS → MID → TREB → BAL → FAD → LOUD → SVC → VOL → BASS → ...<br />
Turn the [VOL] rotary knob to the right or left in the audio mode while referring to the table below<br />
to adjust the sound.<br />
Mode Function [VOL] Rotary knob/Function<br />
BASS<br />
Adjusts bass level.<br />
Turn to the right Emphasizes low sounds.<br />
Turn to the left Softens low sounds.<br />
Emphasizes<br />
Turn to the right<br />
MID (MIDDLE) Adjusts middle level.<br />
mid-range sounds.<br />
Turn to the left Softens mid-range sounds.<br />
TREB (TREBLE) Adjusts treble level.<br />
Turn to the right Emphasizes high sounds.<br />
Turn to the left Softens high sounds.<br />
BAL (BALANCE)<br />
Adjusts left/right speaker Turn to the right Emphasizes right speakers.<br />
balance (BALANCE). Turn to the left Emphasizes left speakers.<br />
FAD (FADER)<br />
Adjusts front/rear speaker Turn to the right Emphasizes front speakers.<br />
balance (FADER). Turn to the left Emphasizes rear speakers.<br />
<strong>TNS400</strong> 15
Change language