Manual 1.3 - DJ Sound Hire

PREMIUM PR:O Manual 1.3
1 Aligning Cabinets with
DuoTilt
The novel integrated DuoTilt pole mount allows
sound energy to be utilized far more efficiently.
With two angles of tilt to choose from, 3° and 7°, the
enclosure can be aimed directly at the audience.
The cabinet is stabilized at its center of gravity – no
wobbling, unwanted tilting, or unintentional turning.
Your choice of DuoTilt angle – 3° or 7° – depends
on the required speaker height and the size of the
room. If you set mid/high units on fully extended
tripods or mounting poles, select 7° to minimize
ceiling reflections.
If you want to address an audience where more
listeners are farther away from the speakers, use the
HK Audio® DuoTilt at the 3° angle.
Mono Tilt 3 (PR:O 8 A) offers one angle of tilt.
2 Connecting Components and
Speakers
HK Audio ® speaker cords with a diameter of 2 x 2.5
sq. mm are recommended for connecting cabinets,
power amps or powered mixing consoles. Cords are
available in the following lengths:
1. LSC 3, item no.: 193283, 3 m
2. LSC 7, item no.: 193263, 7 m
3. LSC 15, item no.: 193323, 15 m
Recommended Amplifier Power Output
Connect amps rated from 600 W @ 4 W RMS to 800 W
RMS @ 4 W per amp channel to power the PREMIUM
PR:O cabinets. To have enough headroom available
for dynamic musical signals, the power amp should
deliver peak performance of at least 1,200 W @ 4 W
per channel.
Note:
An electrical connection between the cord and input
jack is not established until the Speakon connector
locks into place. Twist the Speakon connector clockwise
until it engages.
Figure 1: 3° and 7° angles of tilt
2.1 PR:O 8, PR:O 10 X, PR:O 12, PR:O 15 and
PR:O 15 X in Full-range Mode
Connect the speaker output from the powered mixer
or power amp to the input (IN) of the PR:O 8,
PR:O 10 X, PR:O 12, PR:O 15 and PR:O 15 X full-range
speaker cabinet.
Figure 2.1: Powered mixer and/or mixer and a power amp