ROTO SILENTA 630 RS - Hettich Instruments
ROTO SILENTA 630 RS - Hettich Instruments
ROTO SILENTA 630 RS - Hettich Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
EN<br />
35 Faults<br />
If the fault cannot be eliminated with the help of the fault table, please inform Customer Service.<br />
Please specify the type of centrifuge and the serial number. Both numbers can be found on the name plate of the<br />
centrifuge.<br />
Perform a MAINS RESET:<br />
− Switch off the mains switch (switch position "0").<br />
− Wait at least 10 seconds and then switch on the mains switch again (switch position "Ι").<br />
Message / fault Cause Remedy<br />
No display --- No voltage.<br />
− Check supply voltage.<br />
Overvoltage protection tripped out (only for − Mains switch ON.<br />
types 5005-08).<br />
TACHO - ERROR 01 Faulty speedometer.<br />
− Open the cover.<br />
02 No rotor installed.<br />
Defective motor, frequency converter or<br />
− Switch off the mains switch<br />
(switch position "0").<br />
drive.<br />
− Wait at least 10 seconds.<br />
− Turn the rotor vigorously by hand.<br />
− Switch on the mains switch again<br />
(switch position "Ι"). The rotor<br />
must turn during switch-on.<br />
IMBALANCE /<br />
--- The rotor is unevenly loaded. − Open lid.<br />
UNWUCHT<br />
− Check the loading of the rotor,<br />
see chapter "Loading the rotor".<br />
− Repeat the centrifugation run.<br />
CONTROL - ERROR 04, Error in lid locking or lid closure.<br />
06 - 09<br />
N > MAX 05 Rotation too fast<br />
− Perform a MAINS RESET.<br />
N < MIN 13 Rotation too slow<br />
<strong>ROTO</strong>RCODE 10 Incorrect rotor coding<br />
MAINS INTERRUPT --- Power failure during the centrifugation run. − Open lid.<br />
(The centrifugation run was not finished.) − Push START button.<br />
− Repeat the centrifugation run if<br />
necessary.<br />
VE<strong>RS</strong>IONS-ERROR 12 Mismatch between electronic components<br />
SER I/O - ERROR 30 - 38 Error / defective interface<br />
° C * - ERROR 50 – 56, Error / defective cooling<br />
58<br />
LOCK - ERROR 57 Error / defective program locking<br />
− Perform a MAINS RESET.<br />
FU / CCI - ERROR 60 - 83 Error / defective motor control<br />
CONTROL-ERROR 26,<br />
90 – 95,<br />
97 - 99<br />
Error / defective control unit<br />
N > <strong>ROTO</strong>R-MAX 96 Speed in the selected program greater than<br />
the maximum speed of the rotor (n-max-<br />
Rotor).<br />
− Check the set speed.<br />
Reduce the set speed<br />
46/102