KESSEL-Kleinkläranlagen INNO-CLEAN® - Kessel Design

8. Control of the septic system
8.1.System menu
System Information
Systeminfo
Time: Uhrzeit: 00:00:00
Floater: Schwimmer On/Off 1: Ein / Aus
TX: TX: (Phase T1 T1 - bis T24T24)
TX1: TX1: (time: (Zeit: 00:00:00)
Informationen
Maintenance
Wartung
Positions Einstellungen
B
0 System Information
Time:
Floater:
T1 Feeding
TX1< 00:05:54 Feeding
Display of the hierarchy level
Time
Display of the activated floaters and their position
Display of the phase
Display of the currently expired time of the respective phase
Display of alarm/fault information
8.2 Information menu
Information
Systeminfo Systeminfo
Informationen
Uhrzeit: Time: 00:00:00 Uhrzeit: 00:00:00
Schwimmer Floater: Schwimmer 1: Ein On/Off / Aus 1: Ein / Aus
TX: (Phase TX: TX: T1 Phase (Phase bis T24) T1 T1 -bis T24T24)
TX1: (Zeit: TX1:
TX1: 00:00:00) (time: 00:00:00)
(Zeit: 00:00:00)
Wartung Maintenance
Wartung
Positions Einstellungen
8.3 Maintenance menu
System
Information
Systeminfo
Informationen
Maintenance Wartung
Positions Einstellungen
Attendend Betriebsstunden
B time
Events/Errors
Ereignisse / Fehler
Command Steuerungstyp type
Maintenance Wartungstermin Date
Water Wasserhöhe level
Parameter
man. Handbetrieb operation
test Testbetrieb operation
Maintenance Wartungstermin Date
8.2.2G
Incidents / faults
Display of chronological faults and incidents (see also
chapter 10 "Malfunctions and remedial measures")
All changes made to the settings are saved at this point.
8.2.3 Control type
Display of purification class, size, language and software
version
8.2.4 Maintenance deadline
Display of the next necessary and last performed maintenance
Note: Data are only available if these have been stored
in the menu "Settings" by the maintenance partner. (see
also 8.3.3)
8.2.5 Water level
Pressing the OK key carries out a measurement of the
current water level in the aeration basin.
8.2.6 Parameters
Display of all set control parameters of the plant. Changing
the parameters is not possible in this menu (see also
8.4.1 and 8.4.2)
8.3.1 Manual operation
Manual operation overrides automatic operation. Manual
activation of the ventilation plate lifters and of the
aerator spark plug.
8.3.2 Test operation
Automatic test of the valves in the valve block. The compressor
is not switched on during this process.
117