Model AV1-LED Audio-Visual LED Light - Federal Signal
Model AV1-LED Audio-Visual LED Light - Federal Signal Model AV1-LED Audio-Visual LED Light - Federal Signal
14 ■ Installation and Maintenance Manual LENS GASKET BLACK WIRES FROM SOUNDER POWER PCBA O-RING (3) MOUNTING SCREW (2) Figure 6 Exploded view with sounder THREADED STUD Model AV1-LED Lights LENS LOCKING SCREW AV1LED STICK PCBA (3 REQUIRED) PCBA STANDOFF (3) #8 SCREW (3) UPPER HOUSING FLAT WASHERS (3) SOUNDER LOWER HOUSING 290A6508
Replacing the Sounder Installation and Maintenance Manual ■ Occasionally check for a reduction in the output of the sounder. If the sound pressure is reduced to an ineffective level, replace the sounder. SHOCK HAZARD—Do not connect the light to the system while the power is on. Failure to heed this warning may cause serious injury or death. Accessing the Sounder The sounder is located on the bottom of the upper housing (Figure 6 on page 14). To access the sounder: 1. Turn off power to the system. 2. Loosen the lens locking screw and twist the lens counterclockwise one-quarter turn. Remove the lens from the upper housing. 3. Loosen the screws on terminal block J9 on the PCBA and remove the black leads of the sounder. 4. The mounting holes permit only one orientation of the PCBA. Note or mark the orientation. 5. Use a flat-head screwdriver to carefully pry the PCBA from the three nylon standoffs and set the PCBA aside. 6. Remove the three #8 screws securing the upper housing to the lower housing and remove the upper housing. Replacing the Sounder and Reassembling the Light 1. Unscrew the sounder from the upper housing (Figure 5 on page 12). Be careful to not lose the three washers that space the sounder from the upper housing. 2. Place the washers on the threaded lug of the new sounder and hand-tighten the sounder. Model AV1-LED Lights 15
- Page 1 and 2: 2561528A REV. A 512 Printed in U.S.
- Page 3 and 4: Contents Safety Messages to Install
- Page 5 and 6: Installation and Maintenance Manual
- Page 7 and 8: Installation and Maintenance Manual
- Page 9 and 10: Installation and Maintenance Manual
- Page 11 and 12: Installation and Maintenance Manual
- Page 13: Installation and Maintenance Manual
- Page 17 and 18: Installation and Maintenance Manual
- Page 19 and 20: Installation and Maintenance Manual
- Page 21 and 22: DEL audio-visuelle modèle AV1 Manu
- Page 23 and 24: Table des matières Messages de sé
- Page 25 and 26: Manuel d’installation et d’entr
- Page 27 and 28: Manuel d’installation et d’entr
- Page 29 and 30: Manuel d’installation et d’entr
- Page 31 and 32: Manuel d’installation et d’entr
- Page 33 and 34: Manuel d’installation et d’entr
- Page 35 and 36: Manuel d’installation et d’entr
- Page 37 and 38: Manuel d’installation et d’entr
- Page 39 and 40: Tableau 2 Pièces de rechange Manue
- Page 41 and 42: Modelo AV1-LED Luz LED audiovisual
- Page 43 and 44: Contenido Mensajes de seguridad par
- Page 45 and 46: Installation and Maintenance Manual
- Page 47 and 48: Installation and Maintenance Manual
- Page 49 and 50: Installation and Maintenance Manual
- Page 51 and 52: Installation and Maintenance Manual
- Page 53 and 54: Installation and Maintenance Manual
- Page 55 and 56: Reemplazo de la sirena Installation
- Page 57 and 58: Installation and Maintenance Manual
- Page 59 and 60: Installation and Maintenance Manual
14<br />
■ Installation and Maintenance Manual<br />
LENS GASKET<br />
BLACK WIRES<br />
FROM SOUNDER<br />
POWER PCBA<br />
O-RING (3)<br />
MOUNTING SCREW (2)<br />
Figure 6 Exploded view with sounder<br />
THREADED STUD<br />
<strong>Model</strong> <strong>AV1</strong>-<strong>LED</strong> <strong>Light</strong>s<br />
LENS<br />
LOCKING SCREW<br />
<strong>AV1</strong><strong>LED</strong> STICK PCBA<br />
(3 REQUIRED)<br />
PCBA STANDOFF (3)<br />
#8 SCREW (3)<br />
UPPER HOUSING<br />
FLAT WASHERS (3)<br />
SOUNDER<br />
LOWER HOUSING<br />
290A6508