Model AV1-LED Audio-Visual LED Light - Federal Signal
Model AV1-LED Audio-Visual LED Light - Federal Signal
Model AV1-LED Audio-Visual LED Light - Federal Signal
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation and Maintenance Manual ■<br />
4. Route separate supply wires of the appropriate gauge for the<br />
light and sounder into the housing through the conduit entry.<br />
5. Strip a maximum of 0.25 in (6.4 mm) of wire insulation from<br />
the ends of the power leads.<br />
6. See Figure 4. To connect the wires to the terminal block, insert<br />
the stripped ends of the wires into the connector as far as<br />
they can go, then tighten the clamping screw. The maximum<br />
tightening torque is 4.5 in-lb (0.5 N•m).<br />
NOTE: If it is necessary to combine two NEUTRAL/– wires,<br />
connect them to the same terminal on the terminal block.<br />
7. Reassemble the <strong>Model</strong> <strong>AV1</strong>-<strong>LED</strong>, restore power, and test the<br />
unit for proper operation.<br />
LINE/+ (SOUNDER)<br />
LINE/+ (LIGHT)<br />
NEUTRAL/−<br />
Figure 4 Wiring for separate power supplies<br />
RED<br />
YELLOW<br />
WHITE<br />
PCBA<br />
CONNECTOR<br />
290A6507<br />
<strong>Model</strong> <strong>AV1</strong>-<strong>LED</strong> <strong>Light</strong>s 11