GroupShield 5.2 for Exchange 2000 Installation Guide - McAfee

Installing the Software
Installing the software from the command line
You can install GroupShield 5.2 for Microsoft Exchange 2000 from the
command line, using the msiexec command. This command runs the
installation program SETUP.MSI.
WARNING: Do not run msiexec directly from the command line on a
system that has any previous versions of GroupShield Exchange
installed.
The syntax of msiexec is:
msiexec /i setup.msi
[STOPFORMINSTALL=Y]
[INSTALLDIR=]
[GSECONFIGFILE=]
NOTE: The command must be on a single line. Each parameter and its
value is joined with an equals sign without spaces. If you need to include
a space, you must enclose the value in a double-quote ("). For example:
INSTALLDIR="C:\Program Files\McAfee"
The parameters have the following effects:
STOPFORMINSTALL=Y
Defines whether the organizational forms will be installed. If not
specified, the forms are installed.
INSTALLDIR=
Defines the directory where you want to install GroupShield. If not
specified, the installation process prompts you for this information.
NOTE: During a silent installation, as described in “Using SETUP.INI to
customize the installation” on page 32, you are not prompted for the
directory. GroupShield installs to the default installation directory on the
boot drive:
:\Program Files\McAfee\GroupShield Exchange (where is
the boot drive).
ENG-26 GroupShield version 5.2 for Microsoft Exchange 2000