GroupShield 5.2 for Exchange 2000 Installation Guide - McAfee
GroupShield 5.2 for Exchange 2000 Installation Guide - McAfee
GroupShield 5.2 for Exchange 2000 Installation Guide - McAfee
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installing the Software<br />
6 Read the Network Associates software license agreement carefully. If<br />
you install the software, you agree to abide by the terms of the license.<br />
To accept the license terms, click Accept.<br />
If you do not agree to the license terms, click Cancel. The installation<br />
stops (no changes are made to your system).<br />
7 View the Readme In<strong>for</strong>mation that is displayed.<br />
You can also view and print the complete Readme file, README.RTF,<br />
located in the same folder as SETUP.EXE. This contains important last<br />
minute in<strong>for</strong>mation about this release of the software.<br />
8 Click Next> to display the Destination Folder dialog box.<br />
9 To install the software to the default folder, click Next>.<br />
To specify a different installation folder, click Browse> and select the<br />
folder required, then click OK.<br />
10 Click Next> on the Start <strong>Installation</strong> dialog box to continue.<br />
The Updating System dialog box opens, displaying progress messages<br />
and a progress bar. The <strong>GroupShield</strong> files are copied and the software is<br />
installed.<br />
NOTE: While the files are being copied, clicking Cancel displays a<br />
confirmation window, allowing you to select Exit Setup, which<br />
returns the system to its previous state, or Resume, which continues<br />
the installation. Once the Microsoft Installer (MSI) starts the<br />
installation process, you cannot cancel the installation process.<br />
On completion, the <strong>GroupShield</strong> <strong>for</strong> <strong>Exchange</strong> <strong>2000</strong> has been successfully<br />
installed dialog box opens.<br />
11 Click Finish to open the <strong>GroupShield</strong> <strong>Exchange</strong> Setup Wizard.<br />
12 To configure your system:<br />
a Click Configure to open <strong>GroupShield</strong> <strong>Exchange</strong> within the Microsoft<br />
Management Console (MMC). Then, either:<br />
– Right-click Configuration and choose Properties.<br />
– Click Configuration and choose<br />
ENG-24 <strong>GroupShield</strong> version <strong>5.2</strong> <strong>for</strong> Microsoft <strong>Exchange</strong> <strong>2000</strong>