APC Back-UPS Pro® - APC Media

More documents

Recommendations

Info

4 3. Presentation 3.1 Front panel Press the on/of on/of on/off on/of button with the UPS plugged in to turn the UPS on or off. See Sec. 5.1. On/of On/off On/of also activates the UPS’s self-test. See section 5.2. The over er er erload er load LED illuminates when the loads connected to the UPS exceed the UPS’s power capacity. See section 6.2. The replace place ba batter ba tter ttery tter LED illuminates when the UPS’s battery is no longer useful and must be replaced. See section 10. The on-ba on-ba on-batter on-ba tter ttery tter LED illuminates when the UPS is supplying battery power to the loads. The on-line on-line LED means that filtered utility line is passing through the UPS to your equipment. The input input input po power po er connector connector is a power cord with a NEMA 5-15P connector. The output output po power po er receptacles are NEMA 5-15R type. The RJ-45/RJ-11 modular combination is used for tele telephone/netw tele phone/netw phone/networ phone/netw or ork or k sur surge sur e e pr protection pr otection with single telephone lines and 10Base-T networks. See section 4.5. The computer computer interf interface interf ace por port por is for UPS monitoring and control. See section 4.4.
3.2 Rear Panel The site site wiring wiring f ffault f fault ault indica indicator indica tor illuminates when the UPS is connected to an improperly wired AC power outlet. See section 4.9. The input input cir cir circuit cir circuit cuit br break br eak eaker eaker er trips when loads exceed the UPS’s capacity. The resettable center plunger of the circuit breaker extends when tripped. 4. Installation Please fill out and return the warranty registration card now. 4.1 Inspection Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is recyclable; save it for reuse or dispose of it properly. 4.2 Placement Install the UPS in a protected area with adequate air flow that is free of excessive dust. Do not operate the UPS where the temperature and humidity is outside the specified limits. See section 12. Allow the UPS to come to room temperature before continuing. 5 English
Page 1: APC Back-UPS Pro® Uninterruptible
Page 4 and 5: Part Number 990-2012-C Revised 10/9
Page 6 and 7: Garantía Limitada American Power C
Page 8 and 9: 2 1.2 Radio Frequency Interference
Page 12 and 13: 6 4.3 Protection Strategies This UP
Page 14 and 15: 8 5. Operation 5.1 Switch On — Sw
Page 16 and 17: 10 7.2 Wall Mount Bracket A special
Page 18 and 19: 12 10. Battery Replacement This UPS
Page 20 and 21: 14 10.4 Battery Replacement Procedu
Page 22 and 23: 10Base-T surge protection let-throu
Page 24 and 25: 18 Notes
Page 26 and 27: 20 1.2 Interférences radioélectri
Page 28 and 29: L’onduleur dispose d’une source
Page 30 and 31: 24 4.2 Choix d’un emplacement Ins
Page 32 and 33: prise de secteur mal câblée. Les
Page 34 and 35: 28 6.3 Batterie à remplacer Si le
Page 36 and 37: 30 Problème Cause possible Solutio
Page 38 and 39: 32 10.3 Procédure de remplacement
Page 40 and 41: 34 11.2 Stockage longue durée En c
Page 42 and 43: 36 13. Comment déterminer l’auto
Page 44 and 45: 38 1.2 Interferencia con Radio Frec
Page 46 and 47: El SAI tiene una fuente interna de
Page 48 and 49: 42 4.3 Estrategias de Protección E
Page 50 and 51: 44 5. Operación 5.1 Encender - Apa
Page 52 and 53: 46 7. Opciones 7.1 Juegos de interf
Page 54 and 55: 48 9. Servicio Si el SAI requiere s
Page 56 and 57: 1. Coloque el SAI sobre su lado izq
Page 58 and 59: 52 Energía de sobrevoltaje transit
Page 60:
54 Notas
show all

APC Back-UPS Pro® - APC Media

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?