Texte intégral en version PDF - Epublications - Université de Limoges

284 Bibliographie
[Fazilleau, 2003]- J. Fazilleau, «Contribution à la compréhension des phénomènes impliqué
dans la réalisation de dépôts finement structurés d’oxydes par projection de suspensions par
plasma », Thèse de l'Université de Limoges n°ordre: (2002).
[Fincke et al, 2000]-J.R.Fincke, WD.Swank, D.C.Haggard, « More on the influence of
injector geometry and carrier gas flow rate on spray pattern and particle temperature », in
Thermal Spray : surface engineering via applied research, (ed) C.C. Berndt, (pub) ASM
International, Materials Park, OH, USA, (2000), 9-14.
[Fox, 1997]- A.C FOX, " The gas permeability of plasma sprayed ceramic coatings", Thermal
Spray 1997: A United Forum for Scientist and Technological Advances, (ed) C.C Berndt ,
(pub) ASM International, Materials Park Ohio-USA, (1997), 483-490.
[Friis et al, 2001]- M. Friis, C. Persson, J. Wigren, “Influence of particle in-flight
characteristics on the microstructure of atmospheric plasma sprayed yttria stabilized zirconia”,
Surface and coatings technology, 141, (2001), 115-127
[Fukanuma, 1996]- H. Fukanuma," Mathematical modelling of flattening process on rough
surfaces in thermal spray", in Thermal Spray : practical solutions for engineering problems,
(Ed.) C.C.Berndt, (pub) by ASM International, Materials Park Ohio, USA, (1996), 647-656.
[Fukumoto et al, 1995]-M. Fukumoto, S. Katoh, I. Okane « Splat behavior of plasma sprayed
particles on flat substrates », in Thermal Spraying : Current Status and Future Trends, (Ed)
A.Ohmori, (Pub) Society of High Temp. of Japan, Osaka, Japan, (1995), 353-358.
[Fukumoto, 2001]- M. Fukumoto, « Proposal of new criterion for splashing of thermal
sprayed particle onto flat substrate surface », in Thermal Spray 2001 : new Surfaces for a New
Millennium,(Ed) C.C. Berndt, K.A. Khor, and E.F. Lugscheider,(pub) by ASM International,
Materials Park, Ohio,USA, (2001), 841-848.
[Funcke, 1997]- C. Funke, "Properties of ZrO2-7wt%Y2O3 Thermal barrier coatings in
relation to plasma spraying conditions", in Thermal Spray 1997.A United Forum for Scientist
and Technological Advances, (ed) C.C. Berndt, (pub) ASM international, Material Park,
Ohio, USA, (1997), 277-284
[Ghafouri-Azar et al, 2001]- R. Ghafouri- Azar, J. Mosthagimi, « Deposition model of
thermal spray coatings », in Thermal Spray 2001 : new Surfaces for a New Millennium,(Ed)
C.C.Berndt, K.A.Khor, and E.F.Lugscheider, (pub) ASM International, Materials Park,
Ohio,USA,(2001), 951-958.