スペアタイヤキット - Volvo Cars Accessories Web

EN Spare wheel kit
10
Spare wheel
Note!
Volvo recommends only using the
jack that belongs to the respective
car model, which is indicated by the
jack decal.
The decal also indicates the jack’s
maximum lifting capacity at a given
lowest lifting height.
2 Take out the jack and wheel brace
from under the load floor in the cargo
compartment.
3 Remove any fully covering wheel hubs.
4 Chock in front and behind the wheels
thataretoremainonthe ground. Use
substantial wooden blocks or large
stones.
5 Undo the wheel studs ½ 1 turn
anticlockwise using the wheel brace.
Warning!
Never place anything between the
ground and jack, nor between the
jack mounting and jack.
6 There are two jacking points on each
side of the car. At each point there is a
cut-out in the plastic cover. Lower the
jack foot so that it is pushed flat against
the ground.
Caution!
The ground must be firm, flat and
smooth.
7 Lift the car enough that the wheel
hangs freely. Remove the wheel studs
and lift the wheel off.
Installing
1 Clean the mating surfaces between the
wheel and hub.
2 Install the wheel. Screw the wheel
studs into place.
3 Lower the car so that the wheel cannot
rotate.
4 Tighten the wheel studs crosswise. It
is important that the wheel studs are
properly tightened. Tighten to 140 Nm.
Check the tightening torque using a
torque wrench.
5 Install the wheel cover (for cars wheel
steel rims).
Note!
The hubcap’s hole for the valve must
be over the valve on the rim when
installing.