1e - Viking

Important! Remove the 2 plastic plugs
from drain holes on container side pointing
towards deck to create drains in container .
The drain holes enable condensed water
to run out of the container. Remove above
mentioned plastic plugs by means of a
knife.
Mounting instructions for Yaching raft
in cradle installed on deck
5a Container
5b Short black lashing strap
5c Drain plugs
5d Launching instruction
5e Railing
5f Cradle
5g Hydrostatic release unit (HRU)
5h Painter line
5i Shackle
5
Mounting instructions for cradle installed
on deck:
5f.1 Mounting fittings for the short black
lashing strap.
5f.2 Delivered by customer
M10 Bolts
M10 Lock nuts
ø10 Washers
5f.3 Hole for shackle only used for
mounting of painter line without
HRU.
5f.4 Mount fittings for HRU on cradle.
5f.5 M6 x 35 Bolt.
M6 Lock nut
ø6 Washer
Mounting instructions for container in
cradle with Hammar hydrostatic release
unit (HRU):
1.1 Bolt cradle on deck.
1.2 Place black short lashing strap in
the fittings. See page 2 position 1.
1.3 Mount container in cradle.
1.4 Place the longest lashing strap in
the HRU and close buckle. Tighten
up lashing.
Mounting instructions for container in
cradle without HRU
2.1 Mount as described in sections
1.1, 1.2 and 1.3. Place the longest
black lashing strap in the fittings
on the cradle. Close buckle.
Tighten up lashing.
Important! Remove the 4 plastic plugs
from drain holes on container side pointing
towards deck to create drains in container.
The drain holes enable condensed water to
run out of the container. Remove above
mentioned plastic plugs by means of a
knife.
19