Bedienungsanleitung Operating Instructions Mode d'emploi ... - Siku

More documents

Recommendations

Info

First aid Here is a list of the faults that might arise. 11 Does the model respond? Repeat step 10. If that doesn’t help, contact service. REMOTE CONTROL MODULE 18 10 Switch on the hand-held transmitter. Switch on the model. Are the corresponding level keys lit? Turn the hand-held transmitter off and on again. Switch vehicle off and on again. Step 11. 9 Are the batteries properly inserted? (As per the instructions in the case). Insert batteries properly. Insert fully charged batteries. If the SIKU-light still does not flash, check with dealer service. 8 Is the SIKU indicator light on? Step 9. Step 10. 7 Is the module switched on? Press the SIKU indicator light key. The SIKU indicator light is on Step 8. 6 Is the mains adapter in the socket? Plug in the power supply. Contact dealer service. VEHICLE / STORAGE BATTERY 5 Does the red light on the battery charger light permanently without the storage battery? Step 6. Reinsert battery tightly into charger. When green light flashes, battery is being charged. When green light stays on, battery is fully charged. Reinsert battery into vehicle case and repeat step 2. 4 Is the battery chareged? Replace into charger and switch to ON. Does the green light flash? Step 5. Battery is being charged. It is fully recharged when green light stays on. Insert again into model and repeat step 2. 3 Is the storage battery properly inserted into the vehicle case? Remove battery and reinsert by pressing tighter. Then repeat step 2. Step 4. 2 Does the light flash constantly? Step 3. Step 7. 1 Is the model switched on? Change position from “OFF“ to “ON“ at storage battery switch. Step 2. NO YES
FAQ You will find descriptions of the faults here. FAULT CAUSE FAULT ELIMINATION Change/charge batteries/storage batteries in the hand-held transmitter. Charge storage battery vehicle. Switch off and on again or run scan on the hand-held transmitter (new connection set-up). Switch model off and on again. Battery/storage battery voltage is too low. No connection between the hand-held transmitter and the vehicle. Transmission fault. Change/charge batteries/storage batteries in the hand-held transmitter. Charge storage battery in the vehicle. Switch off and on again or run scan on the hand-held transmitter (new connection set-up). Switch vehicle off and on again. Battery/storage battery voltage is too low. Transmission fault. Malfunctioning in the vehicle (jerking in coupling, movement in engine without the corresponding keys on the hand-held transmitter being activated). Switch off and on again or run scan on the hand-held transmitter (new connection set-up). Switch model off and on again. Transmission fault (The vehicle could not be assigned to the right level). The corresponding level key light is not on although there is a connection to the vehicle. Although the corresponding level key light is not on, the model is functioning properly. Switch off and on again or run scan on the hand-held transmitter (new connection set-up). Switch model off and on again. Transmission fault (The vehicle could be assigned to the right level but a connection could not be established). The corresponding level key light is on but there is no connection to the vehicle. Fault in connection and transmission. Press through the corresponding level keys again. Otherwise, switch off and on again or run scan on the hand-held transmitter (new connection set-up). Switch model off and on. When switching through the stored models, it is not possible to establish a connection. 19
Page 1 and 2: Bedienungsanleitung Operating Instr
Page 3 and 4: Die Symbole The Symbols Les Symbole
Page 5 and 6: Das Funk-Fernsteuermodul SCAN LEVEL
Page 7 and 8: Vor dem ersten Start: Laden des Akk
Page 9 and 10: Batterien vor dem Laden aus dem Fer
Page 11 and 12: FAQ Hier finden Sie eine Fehlerbesc
Page 13 and 14: The radio control module SCAN LEVEL
Page 15 and 16: Before starting for the first time,
Page 17: Safety instructions SIKU toy model
Page 21 and 22: Le module de télécommande radio S
Page 23 and 24: Avant le premier démarrage: rechar
Page 25 and 26: Remarque concernant les piles (modu
Page 27 and 28: FAQ Voici untableau avec des pannes
Page 29 and 30: Radiografische afstandsbesturing SC
Page 31 and 32: Voordat voor de eerste keer gestart
Page 33 and 34: Kipfunctie van de bak De kipfunctie
Page 35 and 36: FAQ Hier is een omschrijving van de
Page 37 and 38: El módulo de telemando por radio S
Page 39 and 40: Antes del primer arranque: carga de
Page 41 and 42: Función basculante de la tolva Act
Page 43 and 44: FAQ Aquí encontrará una descripci
Page 45 and 46: Il modulo di radiocomando a distanz
Page 47 and 48: Antecedentemente al primo avviament
Page 49 and 50: Annotazioni di sicurezza I modelli
Page 51 and 52: FAQ Nel seguito viene riportata una
Page 53: Konformitätserklärung gemäß Ric

Bedienungsanleitung Operating Instructions Mode d'emploi ... - Siku

Create successful ePaper yourself

Delete template?

Save as template?