Gebrauchsanleitung Instruction manual • Mode d ... - EuroOptic.com

30
10. Open Sights
10.1. Foresight with elevation adjustment
• Insert Allen key SW 1.3 into the bore of
the foresight from above, and turn Allen
screw as needed:
• Foresight (spring­supported)
Turning out = shooting deeper,
Turning in = shooting higher.
10.2. Rear sight with lateral adjustment
• The rear sight leaf has bores for Allen key
SW 1.3 at the right and left side.
• When shooting to the left:
set the leaf to the right, loosen the left
headless screw and tighten the right headless
screw.
• When shooting to the right:
set the leaf to the left, loosen the right
headless screw and tighten the left headless
screw.
11. Mounting the Scope
The Blaser bolt action rifle model R8 is prepared
for installation of the Original Blaser
Saddle Mount (DBP). We assume that your
scope has been mounted correctly by your
specialized dealer on the barrel assigned to it.
11.1. Installing the scope
• Open lid of rear and front holding elements
and swivel both to the front/up
with your thumb.
• Hold scope with your right hand at the
center tube, above the mount, so that you
can reach the holding element at the front
with your thumb.
• Hold rifle at the forearm with your left
hand, support buttstock on your thigh.
• Insert the two round studs at the scope
mount carefully into the two oval holes
sunk into the upper right side of the barrel,
tilt scope to the left onto the barrel
and hold it in this position.
• Press the opened holding elements, first
the one in front and then the one in the
back, backwards/downwards with your
thumb, until they reach their stop position
(tension!). (If this is too easy or requires
force, then the mount is maladjusted.
Have your dealer correct this according to
works instructions. The ideal pressure for
closing the holding elements is roughly
the same as the pressure required for the
safety slide (cocking slide) of the rifle.)
• Now close the two lids of the holding
elements.