Gebrauchsanleitung Instruction manual • Mode d ... - EuroOptic.com

28
7.2. Exchanging the magazine insert
R8 with spare magazine:
• Open bolt assembly
• Remove the cartridge from the barrel.
• Remove the spare magazine and unload it.
• Use your index finger or thumb to grip
under the follower tray in the magazine
insert, press the left magazine lip to the
inside at the same time and remove the
magazine insert upwards.
• Insert the magazine insert corresponding
to the caliber of the barrel from above
into the spare magazine.
R8 without spare magazine:
• Unload rifle.
• Remove bolt assembly.
• Remove magazine insert with index finger.
• Insert the magazine insert corresponding
to the caliber of the barrel from above
into the spare magazine.
8. Exchanging the
Bolt Head
8.1. Removing the bolt head
You should best ask your specialized
dealer for a demonstration of this
process.
• Unload your rifle.
• Open bolt assembly and remove it.
• Deposit bolt assembly on a flat surface,
with the lower side pointing upwards.
• Use a small screw driver or similar object
to push the retaining latch to the left, leverage
it out and swivel it up.
• Rotate the bolt head anti­clockwise by a
quarter turn and pull it all the way to the
front.
8.2. Installing bolt head
• Lift the retaining latch in the bolt
assembly.
• Now push the bolt head to be installed
over the firing pin until it touches the stop
in the bolt housing and latch it clockwise
by a quarter turn ( refert to Para. 8.2).
• Stop rotating the bolt head when the
retaining latch can be threaded in the
groove of the bolt head.