Gebrauchsanleitung Instruction manual • Mode d ... - EuroOptic.com

22
1. Assembly, Disassembly
1.1. Assembly
• Insert barrel into receiver, with muzzle
pointing upwards, and hold it there.
• Fasten the two barrel fastening nuts finger
tight with the Allen key provided (SW5).
Do not use extensions!!
R8 with spare magazine:
• Insert the magazine insert from above
in the spare magazine and press it
down.
• Insert the spare magazine with magazine
insert from the bottom into
the bolt handle until both magazine
buttons are caught.
R8 without spare magazine:
• Insert the magazine insert from above
in the magazine chamber and press it
down.
• Put the bolt assembly with the two guide
slide ends thoroughly and parallel to the
action spring guide on the rear of the bolt
assembly.
• Press the magazine insert down and push
the bolt assembly forward into the receiver.
NOTE:
The spare magazine can only be inserted
in the bolt assembly, when the magazine
safety is not activated and the „S“ on the
bottom of the spare magazine is not visible.
NOTE:
Until assembly, the bolt handle has to be
arrested in a rear position, that means in an
angle of approx. 45°. When the bolt handle
has an almost vertical position, the bolt
handle cannot be inserted. Swift the bolt
handle until it latches in the 45° position.
NOTE:
When assembling the R8, please generelly
note, that the barrel, the bolt handle and
the magazine insert correspond to the correct
calibre.
1.2. Disassembly
• Push safety slide (cocking slide) slightly
forward with your thumb (approx. 2 mm),
at the same time, turn bolt handle backwards
with your index and middle finger
(unlock), then pull bolt assembly back in a
straight line.
• Unload rifle (refer to Para. 5).
• Push in the bolt stop and hold it there, at
the same time, pull bolt assembly out towards
the back, using your other hand.
• Loosen the two barrel fastening nuts with
the Allen key provided (SW5).
• Remove barrel.