ETTC'2003 - SEE
ETTC'2003 - SEE ETTC'2003 - SEE
PARAMETER DESCRIPTION This array describes in detail parameter types and the structure associated. Parameter type ID DELAY DATA PARAMETER commentary Analog parameter Optional Optional 1 word The more often the delay and ID are not used. In this case, the arrangement of parameters is ARINC 429 Bus standard parameter ARINC 429 Bus FIFO parameter ARINC standard parameter PROCESSING mode ARINC message parameter PROCESSING mode RS232/422/485 bus PROCESSING mode RS message parameter PROCESSING mode Mandatory Mandatory 2 words Mandatory Mandatory 2 words static Mandatory Mandatory 1 up to 8 words The number of data words depends of the processing application Mandatory Optional The number of data words is dynamic. In this case the length field shall be used. Mandatory Optional 1 up to 8 words The delay is included in one of data words. Mandatory Optional The number of data words is dynamic. In this case the length field shall be used. CAN parameter Mandatory Mandatory 6 words Frequency Count Period parameter Mandatory Mandatory 2 words DISCRETE parameter Mandatory Mandatory AFDX parameter Queuing mode AFDX parameter Sampling mode (single or multi PAYLOAD) AFDX parameter Not acquired data Mandatory Optional Mandatory Optional 1 Word STATUS 4 bits STATUS 8 bits LABEL 8 bits AFDX Payload Left justified AFDX Payload Left justified ARINC DATA 24 bits ARINC DATA 24 bits 12 bits ( 12 Discretes ) right justified PADDING byte PADDING byte Mandatory Optional Statistic & network quality information’s The acquisition time of a given frame shall be written in the IENA header field. The acquisition time of a given frame shall be written in the IENA header field. 6
Conclusion : The ‘IENA Packets’ is the standard AIRBUS for flight and ground test installations. This data format answers to the new request of asynchronous time tagged data produced by the test equipments. The characteristics of ‘IENA Packets’ optimize the tests means and the tools decoding for analysis. . 7
- Page 386 and 387: CONCLUSION - NOS BESOINS FUTURS AIR
- Page 388 and 389: LOGICIELS DE MESURE ET DE TRAITEMEN
- Page 390 and 391: LOGICIELS DE MESURE ET DE TRAITEMEN
- Page 392 and 393: LOGICIELS DE MESURE ET DE TRAITEMEN
- Page 394 and 395: In order to optimize the phase nois
- Page 396 and 397: Photo-oscillator active device Opti
- Page 398 and 399: the inverse of N×N correlation mat
- Page 400 and 401: quasi-synchronous multiuser detecto
- Page 402 and 403: Multiuser Interference Canceler ”
- Page 404 and 405: the inverse of N×N correlation mat
- Page 406 and 407: quasi-synchronous multiuser detecto
- Page 408 and 409: Multiuser Interference Canceler ”
- Page 410 and 411: All these sub-systems can be easily
- Page 412 and 413: 3.5 ACPR RACK Gateway and satellite
- Page 414 and 415: 4.2 COMPONENT DEGRADATION MEASUREME
- Page 416 and 417: Indeed, when the objective of the t
- Page 418 and 419: All the five points can be achieved
- Page 420 and 421: M r Mmax (0 dB, -180°) b = 0 a ωc
- Page 422 and 423: 2 - Test devices at ENSICA Souffler
- Page 424 and 425: Soufflerie à Densité Variable (SD
- Page 426 and 427: Capacité : - pour la charge axiale
- Page 428 and 429: Machine d’essai de fatigue en fle
- Page 430 and 431: torsion. - asservissement de chaque
- Page 432 and 433: KEY 1 WORD IENA PACKET format An IE
- Page 434 and 435: TD: “0” means that the paramete
- Page 438 and 439: BACK UTILISATION de CAMERAS NUMERIQ
- Page 440 and 441: TABLE DES MATIÈRES 1. INTRODUCTION
- Page 442 and 443: 2. CONTEXTE DES ESSAIS Le but des e
- Page 444 and 445: 3. LES BESOINS ET LES CONTRAINTES 3
- Page 446 and 447: 4. CHOIX DE LA CAMERA 4.1 Démarche
- Page 448 and 449: 5.1.4 Adaptations Les deux principa
- Page 450 and 451: Tir d'un missile AIR/AIR éjecté T
- Page 452 and 453: 6. CONCLUSION Cette évaluation mon
- Page 454 and 455: Capteur Intelligent IEEE 1451.4 Pri
- Page 456 and 457: pC/g Piezo Accelerometer mV/g Piezo
- Page 458 and 459: BACK F. Mailly et Al. ETTC 2003 MIC
- Page 460 and 461: 4.2. Sensitivity according to the h
- Page 462 and 463: BACK STUDY OF 3∆t PASSIVE LOCATIN
- Page 464 and 465: ∆t 1 ∆t ∆t 2 = t = t M N −1
- Page 466 and 467: For the speed of the reentry vehicl
- Page 468 and 469: BACK TITLE In orbit satellite Gain
- Page 470 and 471: dBm dBm Results obtain with the con
- Page 472 and 473: 3. NEW METHOD DEVELOPPED FOR IOT SA
- Page 474 and 475: The following figures present the g
- Page 476 and 477: 3.2 Analysis of the contribution Th
- Page 478 and 479: ETSC Annual Activities Gerhard Maye
- Page 480 and 481: BACK Abstract European Telemetry St
- Page 482 and 483: The file structure is also adopted
- Page 484 and 485: BACK The statistical Evaluation Of
PARAMETER DESCRIPTION<br />
This array describes in detail parameter types and the structure associated.<br />
Parameter type ID DELAY DATA PARAMETER commentary<br />
Analog parameter Optional Optional 1 word The more often the delay and ID<br />
are not used. In this case, the<br />
arrangement of parameters is<br />
ARINC 429 Bus<br />
standard parameter<br />
ARINC 429 Bus<br />
FIFO parameter<br />
ARINC standard<br />
parameter<br />
PROCESSING mode<br />
ARINC message<br />
parameter<br />
PROCESSING mode<br />
RS232/422/485 bus<br />
PROCESSING mode<br />
RS message parameter<br />
PROCESSING mode<br />
Mandatory Mandatory 2 words<br />
Mandatory Mandatory 2 words<br />
static<br />
Mandatory Mandatory 1 up to 8 words The number of data words<br />
depends of the processing<br />
application<br />
Mandatory Optional The number of data words is<br />
dynamic. In this case the length<br />
field shall be used.<br />
Mandatory Optional 1 up to 8 words The delay is included in one of<br />
data words.<br />
Mandatory Optional The number of data words is<br />
dynamic. In this case the length<br />
field shall be used.<br />
CAN parameter Mandatory Mandatory 6 words<br />
Frequency Count<br />
Period parameter<br />
Mandatory Mandatory 2 words<br />
DISCRETE parameter Mandatory Mandatory<br />
AFDX parameter<br />
Queuing mode<br />
AFDX parameter<br />
Sampling mode<br />
(single or multi<br />
PAYLOAD)<br />
AFDX parameter<br />
Not acquired data<br />
Mandatory Optional<br />
Mandatory Optional<br />
1 Word<br />
STATUS<br />
4 bits<br />
STATUS<br />
8 bits<br />
LABEL<br />
8 bits<br />
AFDX Payload<br />
Left justified<br />
AFDX Payload<br />
Left justified<br />
ARINC DATA<br />
24 bits<br />
ARINC DATA<br />
24 bits<br />
12 bits ( 12 Discretes )<br />
right justified<br />
PADDING<br />
byte<br />
PADDING<br />
byte<br />
Mandatory Optional Statistic & network quality information’s<br />
The acquisition time of a<br />
given frame shall be written in<br />
the IENA header field.<br />
The acquisition time of a<br />
given frame shall be written in<br />
the IENA header field.<br />
6