Bedienungsanleitung Instruction manual Mode d'emploi ... - Rotel AG
Bedienungsanleitung Instruction manual Mode d'emploi ... - Rotel AG
Bedienungsanleitung Instruction manual Mode d'emploi ... - Rotel AG
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
300701 AroMatica755_Inhalt.qxd 21.9.2010 13:40 Uhr Seite 36<br />
4.9 Energy / ECO <strong>Mode</strong><br />
36<br />
Your appliance is equipped with a modern, programmable power saving function<br />
(ECO <strong>Mode</strong>). It means that the appliance turns to power-saving ECO <strong>Mode</strong> (with minimal<br />
heat output = using less electricity) 3 minutes after it last has been used (factoryset).<br />
When the appliance is started again from ECO <strong>Mode</strong>, the heating up can take a<br />
few seconds longer.<br />
The ECO <strong>Mode</strong> can be deactivated for the appliance to be on full stand-by while switched<br />
on:<br />
• Press the programming button P in order to start program mode.<br />
• Press the > button until the display shows eco-mode<br />
• Press the ok button.<br />
• Press the > button until you see no in the display.<br />
• Confirm with the ok button. Display shows eco-mode<br />
• From this point you can go directly to programming other settings or use the exit<br />
button to leave program mode.<br />
5. Maintenance and care<br />
5.1 Filter use<br />
☛ Please read chapter 4.2 Filter on filter use.<br />
5.2 Changing filter<br />
The effectiveness of the filter is exhausted after about 50 l of water. CHANGE filter<br />
appears in the display alternating with the normal operating message and the service<br />
button (2) blinks.<br />
TIP: Press the service button only when you want to change the filter.<br />
☛ You can continue to brew coffee or draw hot water and steam. However, we<br />
recommend that you change the filter immediately.<br />
• Empty the water tank (17) and change the filter.<br />
• Fill the tank with freshwater and put it back into the coffee machine.<br />
• Press the service button (2). The display shows CHANGE filter / TURN valve.<br />
• Hold a receptacle under the steam-hot water jet (12) and turn the steam/hot water<br />
dial (11) to the right. The system will be rinsed.<br />
• Wait until no more water comes out of the jet and then turned the dial (11) back to<br />
the left.<br />
• The system is ready for operation and the normal message for brewing coffee<br />
appears on the display.