StecaGrid 000+ Master/Slave StecaGrid 000+ Maître/Esclave - Axun
StecaGrid 000+ Master/Slave StecaGrid 000+ Maître/Esclave - Axun
StecaGrid 000+ Master/Slave StecaGrid 000+ Maître/Esclave - Axun
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
EN<br />
4.7 Connecting the communications module<br />
(<strong>StecaGrid</strong> Connect)<br />
If the <strong>StecaGrid</strong> Connect option is used with an external communications connection,<br />
the connection plug is located on the above left of the daughterboard.<br />
An aperture can be cut out in the lower part of the control unit for the cable<br />
feed. After inserting the cable hole can be sealed with the supplied blan plug.<br />
Further information regarding connection of the daughterboard can be found in<br />
the manual supplied with the daughterboard.<br />
The SubD9 plug connector (above right) is only used for maintenance purposes.<br />
Improper use can damage the inverter and will invalidate the warranty.<br />
4.8 Switching the grid voltage on for the first time<br />
When energy is being supplied the inverter continuously checks the quality of<br />
the electricity grid. If the grid quality is poor the inverter will automatically disconnect<br />
itself. The criteria according to which the inverter disconnects itself vary<br />
from country to country and are listed in the table in the appendix. This is the<br />
so-called "table of countries". The specific criteria according to which the inverter<br />
disconnects itself are fixed by law.<br />
When commissioning the inverter, first the language then the country should<br />
be set. Select the country in which the inverter is installed; the inverter thereby<br />
fulfils the national requirements. The setting is made using the display and arrow<br />
buttons.<br />
The country setting can only be carried out once. Following selection, a normal<br />
user can only choose between the standard setting and the chosen country<br />
setting. The enclosure contains a table with countries and the relevant country<br />
setting.<br />
If the wrong country setting is still selected this country setting can be changed<br />
by an installer who has the necessary service software.<br />
After connecting the AC side with the grid the inverter autonomously synchronises<br />
with the mains.<br />
7 6.439 | 10.04<br />
39