4497 -Micro Star 700 - DE - EN - FR - CMC-Versand
4497 -Micro Star 700 - DE - EN - FR - CMC-Versand
4497 -Micro Star 700 - DE - EN - FR - CMC-Versand
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
14<br />
<strong>Micro</strong> <strong>Star</strong> <strong>700</strong><br />
Installing the radio control system components<br />
The arrangement of the radio control system components is shown in the illustration.<br />
The servos should be installed in the chassis exactly as shown in the drawing, using the screws<br />
supplied with them.<br />
Important:<br />
Check that the servos are exactly at neutral (centre) before fitting the output arms on the output<br />
shafts!<br />
Connect the servos to the receiver in the sequence specified in the instructions supplied with<br />
your RC system. Connect the receiver power supply, switch the transmitter and receiver on, and<br />
move all the transmitter sticks and trims to centre.<br />
Activate the swashplate mixer at your transmitter. The correct setting:<br />
Symmetrical three-point swashplate linkage, two roll servos, one pitch (elevator) servo at the<br />
front.<br />
Now fit the output arms on the servos and tighten the retaining screws. The output levers must<br />
be orientated as shown in the drawings.