BQ GA 04050 def.pmd - Haag-Streit USA
BQ GA 04050 def.pmd - Haag-Streit USA
BQ GA 04050 def.pmd - Haag-Streit USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix A Installation of the equipment<br />
A.1 Mounting the microscope and the<br />
illumination unit<br />
Place the stereo microscope on the saddle bearing of the<br />
microscope arm. Move it forward against the stop piece and<br />
secure with the screw (13) appearing from obliquely below<br />
(use the Allen key 5 mm).<br />
Secure the breath shield (26) by means of the knurled screw<br />
(27) on the inner side of the bearer arm.<br />
Before attaching the illumination unit to the column of the<br />
instrument base, the set screw (53) in the hub of the bearer<br />
arm is to be sufficiently loosened so that its tip no longer<br />
protrudes into the screw hole.<br />
Grasp the illumination unit arm (52) as shown and place in<br />
position.<br />
Tighten the set screw (53) in the hub of the bearer arm with the<br />
small screwdriver.<br />
Small screwdriver<br />
HS-Part number 1001436<br />
Allen key 5 mm<br />
HS-Part number 1001602<br />
A.2 Mounting of headrest and power supply<br />
The corresponding HAAG-STREIT operating instructions<br />
should be observed!<br />
1500.7001000.<strong>04050</strong><br />
13<br />
27<br />
26<br />
52<br />
53<br />
© HAAG-STREIT AG, CH-3098 Koeniz, Switzerland<br />
page 23 / 33