Libretto istruzioni Instructions for use Manual de Instrucciones Mode ...

IF tHe cOFFee-MAker IS NAUGHtY
TROUBLE TROUBLESHOOTING
tHe cOFFee-MAker
MAkeS LIttLe FOAM
tHe cOFFee-MAker
PrODUceS A LUkeWArM
cAPPUccINO
tHe cOFFee-MAker
ALLOWS cOFFee, MILk Or
FOAM tO SPILL OVer tHe tOP
tHere’S SteAM cOMING OUt
FrOM tHe SAFetY VALVe
tHe cOFFee PrODUceD
tASteS BUrNt
tHe cOFFee PrODUceD IS
tOO WeAk Or LUkeWArM
tHe cOFFee-MAker LeAkS
BetWeeN tHe tOP
AND tHe BOILer
tHe BOILer
OF tHe cOFFee-MAker
cANNOt Be UNScreWeD
FrOM tHe tOP
• The filter may be clogged; it must be cleaned.
• The ground coffee you use is not of a traditional type for moka coffee-makers.
Replace with the right blend.
• The injecting nozzle of the S.A.F.E. valve system may be partially clogged; replace It.
• The kind of milk you use may not be appropriate; only use full-cream or partially
skimmed milk.
• Insufficient water In the boiler; increase water level.
• The mesh of the filter is no longer intact or the filter has been damaged. Replace.
• In any case, it is possible to increase the cappuccino temperature by leaving the
coffee-maker on the cooker even after the foam has been produced.
• Too much water or milk in the product; reduce the quantity based on these
instructions for use.
• The milk you use may produce too much foam; reduce the quantity of milk.
• The coffee is too finely ground; change coffee and choose a type suitable for moka
coffee-makers.
• Too much coffee; reduce quantity.
• The S.A.F.E. valve is blocked; perform special cleaning, as described in
“Recommendations “.
• Too much water; reduce the quantity of water in the boiler.
• The coffee used is too finely ground; change the type of coffee.
• Too much coffee; reduce quantity.
• Insufficient water; add more water in the boiler.
• Insufficient coffee; increase quantity.
eNGLISH
Instructions for use and features
• The two parts may not be perfectly screwed together; tighten further.
• There may be coffee residues on the edges of the coffee-holder or the bottom boiler;
clean carefully.
• The temperature of the boiler is still too hot; let the product cool down.
• The boiler has low pressure; the S.A.F.E valve system must be dismantled before
unscrewing.