Rheotest english

Note: If an overall view of the table is necessary, table heading and table data, one could do printing to file
(for example *.pdf) with the help of main menu “File” – “Print”. This file will be inserted then as an object (Insert
-> Object) in the desired document.
9.3.3 Table Settings
Settings for content and look of the table. This setup acts for the actual job and at the same time for all
samples in this job. The settings are divided into five tabs: Table, Tests, Head, Print, Font. All changes made
will be rejected with the button Cancel and Menu Settings is closed. The changes will be accepted and they
become actual ones with the help of OK button.
9.3.3.1 Table
1 – Number of Columns: one column
minimum and ten columns maximum are
possible.
2 – Column definition: the parameter to
display is defined for each column. The
same parameter can occur in several
columns. For parameter meaning see
section Appendix - Result. The column
width is adjusted automatically after
selection of a new parameter and exit from
the column.
Parameters imaging could be varied in user
settings in such a manner that there is
parameter’s name only, symbol only or
combination of both. See for that Appendix
– Heading data.
3 – Cancel: all changes will be rejected and
input display is closed.
4 – OK: all changes will be applied and input
display is closed.
9.3.3.2 Tests
1 – Tests: it is possible to select here the
tests that should be represented. This setting
is active only in that case when sample is
marked in sample tree. It means that all
available tests could be represented.
If only one test was selected in the sample
tree, this setting is ignored.
The setting is active during one analysis and in the following representation. It means that e.g. at one analysis
and one not activated 1 st test, any data will not be displayed as long as the 1 st test is carried out.
For example, the conditioning steps could be hidden with this option.
2 – Set All: all tests will be selected.
3 – Clear All: selection of all tests will be cancelled; data are not represented until the sample is selected.
Representation is still active in case of selection of single tests.
9.3.3.3 Head
Table heading will be shown above the table itself. It could contain additional information to analysis.
This table heading could be configured for every job. In this case it is valid for all samples that are in the job.
46