Rheotest english

Figure 11 Installation of the Plate Guide
2. Place the basic plate with an automatic distance adjustment on the plate guide. For this, the knurled
screw of the basic plate must first be loosened and unscrewed (about 1 cm). By the subsequent insertion
of the basic plate, its coupling must rest on the small surfaces of the plate guide (Figure 11 right).
3. Tighten the knurled screw of the basic plate (Figure 12 left). Thereby the V-shaped gap between the basic
plate coupling and the plate guide disappears (Figure 12 right).
Figure 12 Touchdawn the Basic Plate on the Plate Guide
4. Loosen the knurled screw on the plate guide (9) (Figure 10) and lower the basic plate until it is resting on
the work surface (Figure 13).
26