Zanzibar - Atlantic-comfort.com

1BPower (W)Measurement(A)600 +1000 1108Measurement(B)Measurement(C)277750 +1000 1433 503 262900 +1000 1758 262A23Note: The pinssupplied with thedevice are of thestandard type.In case of a particularstand, useappropriate pins.4 5C3) Connecting the device- The device must be supplied with 230V, 50Hz.- Mains connection must be ensured using a 3-wirecable (Brown=Phase, Blue=Neutral, Black=Pilotwire), through a connecting box. In damp premises,such as bathrooms and kitchens, install theconnecting box at least 25 cm from the ground.- The installation must be equipped with a shuttingoffdevice in all poles having a distance of openingof contact of at least 3 mm.- Ground connection is forbidden.Do not connect the pilot wire (black) to ground.Panel heater cableLive=brownNeutral=bluePilot wire=Black1st case: only one heater2nd case: multiple heatersTwo possible casesLIVENEUTRALElectricitygridThe pilot wire end is insulatedand not further connectedThe pilot wire of all heaters in acontrol group, up to a maximumof 20 units with any one them usedas the Master, are connectedby a 1.0mm 2 220-240V insulated cable- If power cable is damaged or too short, to avoid any danger it must be replaced by a qualified electricianusing special tools.- If a device pilots or is piloted by a 30mA differential (e.g. bathroom), the pilot wire supply must beprotected on this differential.4) How to fit the 2 pegs ?1/Select the locations from the 4 to 6 available, depending on your machine’s output.2/Push the peg into the hole in the channel.3/Screw tight. 1 2 310