MOF96 MOF96E - Service

ENGLISHNever use a light socket.Never connect the live (L) or neutral (N)wires to the earth pin marked E or .For 115 V units with a power rating exceeding 1500 W,we recommend to fit a plug to BS4343 standard.Using an extension cableIf an extension cable is required, use an approvedextension cable suitable for the power input of thistool (see technical data). The minimum conductorsize is 1.5 mm 2 . When using a cable reel, alwaysunwind the cable completely.Also refer to the table below.Conductor size (mm 2 ) Cable rating (Amperes)0.75 61.00 101.50 152.50 204.00 25Cable length (m)7.5 15 25 30 45 60Voltage Amperes Cable rating (Amperes)115 0 - 2.0 6 6 6 6 6 102.1 - 3.4 6 6 6 6 15 153.5 - 5.0 6 6 10 15 20 205.1 - 7.0 10 10 15 20 20 257.1 - 12.0 15 15 20 25 25 -12.1 - 20.0 20 20 25 - - -230 0 - 2.0 6 6 6 6 6 62.1 - 3.4 6 6 6 6 6 63.5 - 5.0 6 6 6 6 10 155.1 - 7.0 10 10 10 10 15 157.1 - 12.0 15 15 15 15 20 2012.1 - 20.0 20 20 20 20 25 -Assembly and adjustmentPrior to assembly and adjustment alwaysunplug the tool.Inserting and removing a cutter (fig. B)• Press and hold down the spindle lock (7).• Using the 17 mm wrench, loosen the collet nut (8)a few turns and insert a cutter.• Tighten the collet nut and release the spindlelock.Never tighten the collet nut without acutter in the collet.Replacing the collet assembly (fig. C)Your Elu router is supplied with a 1/4" collet fitted tothe tool. Two other precision collets are alsoavailable to suit the cutter used. The collet and thecollet nut are inseparable.• Loosen the collet nut (8) completely.• Remove the collet assembly (13).• Fit a new assembly and tighten the collet nut.MOF96E - Setting the electronic speed controldial (fig. A)The speed is infinitely variable from 8,000 to24,000 min -1 using the electronic speed control dial(12).• Turn the electronic speed control dial to therequired level.• Generally, use the low setting for large diametercutters and the high setting for small diametercutters. The correct setting, however, is a matterof experience.1 = 8,000 min -12 = 9,500 min -13 = 11,500 min -14 = 16,000 min -15 = 19,500 min -16 = 22,500 min -17 = 24,000 min -1Adjusting the depth of cut (fig. D)Depth adjustment using the graduation andrevolver depth stop• Loosen the depth stop locking bolt (5).• Unlock the plunge limiter (4) by turning itcounterclockwise.• Lower the router carriage until the cutter is incontact with the workpiece.• Tighten the plunge limiter (4).• Set the exact depth of cut using the graduation (2)or place a depth template between the depth stop(3) and the revolver depth stop (6). The adjustmentrange is indicated by the arrows (14).• Tighten the depth stop locking bolt (5).en - 4 17