Manual EMIBLUE - Soler & Palau

should make sure that the rawl-plugs and the screws provided are suitablefor the type of wall on which the radiator is going to be located.Please note: The minimum distance between the floor and the base ofthe radiator must be 100mm.To install follow the procedure below:1- Mark the location of the upper supports according to Fig. 7/8, followingthe distances in the attached table. Use a support as a template to markwhere the holes should be. Drill the holes and put in the rawl-plugs.2- Fix the two supports for the radiator with the four screws provided.Electrical connection- They are fixed installation radiators. In order to connect them to themains circuit, you should take into account the guidelines which areshown in the Low Voltage Regulations and those for each particularcountry.- The fixed connection should be made by a professional.- These appliances must be earthed.- There must be a thermal magnetic switch or other device that completelydisconnects the electricity supply from the appliance; this devicemust have a separation of the contacts of at least 3mm at all the poles.- When installing the radiator, make sure that the connecting cable cannever be in contact with a hot area of the appliance.- Proceed with the connection to the mains circuit, making sure that thevoltage is the same as that shown on the appliance registration plate.4. CONTROLS (Fig. 9)The equipment consists of:1. - StandBy key:Use to start, stop or block access.2. - Status LED:Will indicate the situation according to status:* LED solid red. Mode: StoppedIn this situation, the equipment will not work under any circumstances, althoughit continues feeding the network.* LED green: Connected mode.In this situation, the equipment is connected, but the radiator is not usingenergy (the resistance is off).* LED amber: Connected+Load modeIn this situation, the equipment is connected and heating.15