advarsel - Esska

Modular router MFK 700 EQTable of contents1 Symbols2 Technical data3 Scope of delivery4 Intended use5 Safety instructions5.1 General safety instructions5.2 Machine-related safety instructions5.3 Emission levels6 Commissioning7 Machine settings7.1 Electronics7.2 Changing the router table7.3 Changing the routing tool7.4 Changing the clamping collet7.5 Adjusting the routing depth7.6 Dust extraction8 Working with the machine8.1 Machine guidance methods8.2 Aluminium processing9 Service and maintenance10 Accessories, tools11 Disposal12 Warranty13 EU Declaration of ConformityThe specified illustrations can be found atthe beginning an at the end of the operatinginstructions. The spare parts list appears atthe end of this operating manual.1 SymbolsWarning of general dangerRisk of electric shockWear a dust mask!Read the Operating Instructions/Notes!Advice or tip122 Technical dataPower consumption720 WRotational speed (no load)10000 - 26000 rpmTool holder8 mm(optional: 6 mm, 1/4"(6.35 mm))Max. routing tool diameter 26 mm/1"Dust extractor connection diameter 27 mmWeight1.9 kgSafety/II3 Scope of delivery[1-1] MFK 700 with large surface routertable[1-2] Side stop with guide rods and fineadjuster[1-3] Extraction hood for large surfacerouter table with extractor connector[1-4] Router table for edge veneer withfeeler roller and extraction hood (onlyin SET scope of delivery)4 Intended useThe MFK 700 EQ is designed for routingwood, plastic and similar materials.The user bears the responsibility for damageand accidents caused by improper use.5 Safety instructions5.1 General safety instructionsWARNING! Read all safety warningsand all instructions. Failure tofollow the warnings and instructions mayresult in electric shock, fire and/or seriousinjury.Save all warnings and instructions forfuture reference.The term „power tool“ in the warnings refersto your mains-operated (corded) power toolor battery-operated (cordless) power tool.5.2 Machine-related safety instructions- Ensure that the router bit is seated firmlyand that it runs perfectly.- The clamping collet and locking nut mustshow no signs of damage.- Only use tools that meet standard EN847-1. All Festool routing tools fulfil theserequirements.- The maximum rotational speed specifiedon the tool must not be exceeded and