TD - Soler & Palau Sistemas de Ventilación, SLU

adequate thermal and overloadingprotection has been connected andadjusted to the corresponding limits.- If a ventilator is installed in a duct, the ductmust be exclusively for the ventilationsystem.Starting up.Before starting up the machine, make surethat:- The apparatus is well secured and theelectrical connections have been carriedout correctly.- The safety devices have been adequatelyconnected.- No loose material or fitting remains can besucked up by the ventilator. If the ventilatorhas been mounted in a duct, make sure itis clear of loose material.- The earth fittings are adequatelyconnected.- The electrical safety devices are correctlyconnected, adequately adjusted and readyfor use.- The wire and electrical connections inputsare correctly sealed and water-tight.and perceptibly shorten the working life ofthe ventilator unit.- While cleaning, great care should be takennot to unstable the propeller or turbine.- All maintenance and repair work should becarried out in strict compliance with eachcountry’s current safety regulations.Recycling.- EEC Standards, together with theresponsibility we should assume withfuture generations in mind, oblige us torecycle all the materials we can. Therefore,please deposit all left-over material andpackaging in their corresponding recyclingcontainers and hand in the replacedmachines to the nearest handler of thistype of waste product.If you have any queries about S&P products,please contact our after-sales service inSpain, or your local S&P dealer in any othercountry. If in doubt, please visit our Web-Page at www.solerpalau.comWhen starting up the machine, make surethat:- The propeller turns in the correct direction.- There are no abnormal vibrations.- If any of the electrical safety devices blow,the apparatus must be quicklydisconnected from the mains supply. Thewhole installation should be carefullychecked before trying to start up themachine again.Maintenance.- Before manipulating the ventilator, makesure it is disconnected from the mainssupply even if it has previously beenswitched off. Prevent the possibility ofanyone else connecting it while it is beingmanipulated.- The apparatus must be regularlyinspected. These inspections should becarried out bearing in mind the machine’sworking conditions, in order to avoid dirt ordust accumulating on the propeller, turbine,motor or grids. This could be dangerous