Untitled - Kerr Hawe

Mixer with wide opening is only for use with
curved tips.
9. Dispense the cement directly into crown
restoration or onto implant, covering all
surfaces. Seat restoration gently onto the
implant, allowing the cement to flow from all
margins.
10. When restoration is properly seated, remove
excess cement. Excess cement is best
removed in its gel state with a scaler or
explorer. Gel state can be achieved by tack
curing excess with a light for approximately
2 seconds, or by allowing the cement to
self-cure for approximately 2-3 minutes
after application.
11. After removal of excess cement, light cure
all surfaces including margins using Demi
curing light for 10 seconds. [1]
12. Use finishing strips for proximal areas.
Polish margins with Gloss Plus discs, cups,
or points. Use HiLuster Plus Dia polishers for
a final high-luster shine.
13. Check occlusion.
Note: Material minimum working time is 2
minutes at ambient temperature; Set time is
approximately 3 minutes at oral temperature.
These times may vary based on storage
conditions, temperature, humidity, and age
of product.
STORAGE: Store at ambient temperature.
Avoid excess heat. For optimum freshness,
refrigeration is optional.
CAUTION: Uncured methacrylate resin may
cause contact dermatitis and damage the pulp.
Avoid contact with skin, eyes and soft tissue.
Wash thoroughly with water after contact.
Kerr Gel Etchant contains Phosphoric Acid. Avoid
contact with skin, eyes, and soft tissue. In case
of contact with skin or eyes, flush immediately
with water. Get medical attention for eyes. Do
not take internally.