AirConServiceCenter ASC2500 - WAECO - AirCon Service

Operation
AirCon Service Center
8.6.3 Filling process
1. Enter the preferred settings and press ENTER to confirm.
Filling
phase?
Yes
No
I
NOTE
2. If “Filling phase” has been selected, enter the required value,
otherwise continue with “Select connections”.
3. Enter the refrigerant oil quantity.
4. Press the cursor key .
5. Enter the additive quantity.
6. Press the cursor key .
7. Enter the refrigerant quantity.
8. Press ENTER to confirm all settings.
• If extraction is taking place in the same process sequence, the quantity of
fresh oil is counted as an additional filling quantity, and is added to the
drained oil quantity extracted beforehand. If this value is set to 0, exactly
the quantity of oil which was extracted will be filled again.
• To add fresh oil or UV additive, a vacuum process must be performed in
the same process sequence. If no vacuum process has been selected,
only refrigerant can be selected in the filling menu.
8.6.4 Selecting connections
ENTER-OK STOP-EXIT
PAG oil ml. 1
UV tracer ml. 7
Refrigerant g. 500
ENTER-OK STOP-EXIT
1. Select the parameters in accordance with the air conditioning system
connections:
• Air conditioning system has a high pressure and a low pressure
connection: Select LP / HP.
• Air conditioning system only has a high pressure connection:
Select HP.
• Air conditioning system only has a low pressure connection:
Select LP.
86
EN