4742 IM Soft Serve - Household Appliance Inc.

SIMPLE-TO-USE INSTRUCTIONS FOR
MAKING SOFT SERVE AT HOME!!!
5 EASY STEPS:
IMPORTANT: Pre-freeze Mixing Canister
for 24 Hours before use.
1. Mix one bag of pre-mix with 2-1/2 cups of chilled water
(or use one of the enclosed recipes) and mix thoroughly.
2. Remove Soft Serve Mixing Canister from
freezer and place upright on a countertop.
Slide the white Mixing Auger, solid end
down, slowly into the Canister until it rests
snugly on the bottom of the Canister (A).
Place the machine's face panel onto the top
of the Mixing Canister (B), making sure
the silver rod goes into the center of the (B)
Mixing Auger. Apply downward pressure
as you twist it clockwise to lock it into place (C).
3. Slide the entire assembly into the machine until it clicks into place (D).
4. Turn blue dispensing knob on top of the machine to "FILL" and then
lift the knob to reveal the "fill" opening. IMPORTANT: Turn machine
"ON" before pouring in mixture (you may hear a slight churning
sound during operation; this is normal and simply represents the motor
and gear driving the mixing auger inside the unit).
5. Pour ingredients into the opening (E), close the cap and turn the knob
to the "MIX" position. In 20 – 25 minutes, turn blue dispensing knob to
"Serve" and you'll have Soft Serve! Do not turn the machine's power
switch to "OFF" until you have finished dispensing all contents of the
Soft Serve Machine.
• When finished dispensing all of the contents of the Soft Serve machine,
turn machine "OFF" and unplug it (while running, the machine will keep
the Soft Serve frozen and ready to dispense for approximately 30 minutes
after the ice cream initially freezes; you can then store any excess
Soft Serve in a freezer-safe storage container for later consumption).
Press the blue "Chamber Release" button on top of machine to remove
Mixing Canister assembly. Then twist Face Panel counter-clockwise to
disassemble Mixing Assembly; turn blue dispensing knob to "Remove"
position and pull up to remove Valve Assembly for cleaning. (If the Valve
ever becomes difficult to turn or remove, smooth operation can be
restored by applying a light application of liquid or spray-on cooking oil).
All pieces can then be washed with warm, soapy water (all but Mixing
Canister are top-rack dishwasher-safe). Always make sure Canister is
dried thoroughly before placing in freezer.
(A)
(C)
(D)
(E)
CAUTION: NEVER IMMERSE THE MAIN BODY OF THE UNIT IN WATER SINCE THIS
IS WHERE THE MOTOR AND ELECTRICAL COMPONENTS ARE LOCATED;
WATER CAN DAMAGE THEM.
5