Automatic Undercounter Ice Maker Máquina ... - Air & Water

More documents

Recommendations

Info

INTRODUCTION The ORIEN FS-55IM Ice Maker produces hard, crystal-clear, gourmet cube ice, and offers convenience for homeowners and hotel guests. An insulated ice storage bin is built in. In addition, you have the option of using an internal or external drainage system. This user's manual is intended as a resource for persons installing, using and servicing the model FS-55IM. It contains valuable information on safety and maintenance. Orien strongly recommends that this manual be kept in a place where it can be accessed when needed. The ORIEN ice maker is designed and manufactured according to the highest standards of safety and performance. It meets or exceeds the safety standard of UL563. Orien USA L.L.C. assumes no liability or responsibility of any kind for products manufactured by Orien USA L.L.C. that have been altered in any way, including the use of any parts and/or other components not specifically approved by Orien USA L.L.C.. Orien reserves the right to make design changes and/or improvements at any time. Specifications and designs are subject to change without notice. Door Caster COMPONENT LOCATIONS 7 Evaporator cover Water distribution tube Evaporator (ice mold) Water trough Float Ice storage bin Control panel Front louver panel
Unpacking Remove packaging materials ICE MAKER INSTALLATION IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker. Remove tape and glue from your ice maker before using. • To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. • Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your ice maker. Cleaning before use Water supply hose Excessive Weight Hazard Use two or more people to move and install ice maker. Failure to do so can result in back or other injury. 8 Power cord Water inlet Drain outlet Ice scoop Ice scoop Drain hose
Page 1: Automatic Undercounter Ice Maker M
Page 4 and 5: ICE MAKER SAFETY Your safety and th
Page 6 and 7: • The fuse (or circuit breaker) s
Page 10 and 11: After you remove all of the packagi
Page 12 and 13: have the proper electrical connecti
Page 14 and 15: Water Supply The water supply shoul
Page 16 and 17: Installation Types This ice maker h
Page 18 and 19: 4. When the ice storage bin is full
Page 20 and 21: IMPORTANT: • Do not touch the pow
Page 22 and 23: gas and moisture. Clean stainless s
Page 24 and 25: making system thoroughly. • NOTE:
Page 26 and 27: TROUBLESHOOTING Before Calling for
Page 28 and 29: LIMITED WARRANTY Orien USA, L.L.C.,
Page 30 and 31: SÍMBOLOS DE SEGURIDAD Su seguridad
Page 32 and 33: máquina se debe conectar a un toma
Page 34 and 35: INTRODUCCIÓN La máquina para hace
Page 36 and 37: Requisitos del lugar de instalació
Page 38 and 39: Por razones de seguridad personal,
Page 40 and 41: Conexiones de entrada de agua La co
Page 42 and 43: todas las conexiones (incluyendo la
Page 44 and 45: tendrá abierto el sensor de lleno
Page 46 and 47: • Saque el recipiente de hielo pa
Page 48 and 49: Limpieza del condensador Un condens
Page 50 and 51: Tablero de control Descripción de
Page 52 and 53: DIAGNÓSTICO DE FALLAS Antes de lla
Page 54: GARANTÍA LIMITADA Orien USA, L.L.C

Automatic Undercounter Ice Maker Máquina ... - Air & Water

Create successful ePaper yourself

Delete template?

Save as template?