Installation Instructions - Mabe
Installation Instructions - Mabe Installation Instructions - Mabe
DIMENSIONS AND SPECIFICATIONS Installation Instructions INSTALLING THE REFRIGERATOR REFRIGERATOR LOCATION • Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures. • Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly. • Install it on a floor strong enough to support it fully loaded. CLEARANCES Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections: 23‘ (33” wide), 23‘/25‘ CustomStyle 25‘, 26‘, 27‘, 29‘ Sides 1/8" (4 mm) 1/8" (4 mm) Top 1" (25 mm) 1" (25 mm) Back 1/2" (13 mm) 1" (25 mm) 24"(61 cm) Cabinet Water Electrical 3/4"(19 mm) Airspace (1/2"[13 mm] Gap + 1/4"[6 mm] Wall Plates) 25"(63.5 cm) Countertop 66 DIMENSIONS AND SPECIFICATIONS (for 23‘ CustomStyle models) 70 1 ⁄4"(178.4 cm) 36" (91.4 cm) 24"(61 cm) DIMENSIONS AND SPECIFICATIONS (for 25‘ CustomStyle models) 72 1 ⁄4"(183.5 cm)* 36" (91.4 cm) 24"(61 cm) *72 1 /4" (183.5 cm) required for full adjustment of mobility wheels. If cabinets installed above refrigerator have doors that are flush to the top of the opening for the refrigerator, then an additional 1/8" may be required to provide clearance for cabinet doors to open freely.
1 A B CONNECTING THE REFRIGERATOR TO THE HOUSE WATER LINE (icemaker and dispenser models) A cold water supply is required for automatic icemaker and dispenser operation. If there is not a cold water supply, you will need to provide one. See “Installing the Water Line” section. NOTES: • Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet. • If your refrigerator does not have a water filter, we recommend installing one if your water supply has sand or particles that could clog the screen of the refrigerator’s water valve. Install it in the water line near the refrigerator. If using GE SmartConnect Refrigerator Tubing Kit, you will need an additional tube (WX08X10002) to connect the filter. Do not cut plastic tube to install filter. If you are using copper tubing, place a compression nut and ferrule (sleeve) onto the end of the tubing coming from the house cold water supply. If you are using the GE SmartConnect tubing, the nuts are already assembled to the tubing. If you are using copper tubing, insert the end of the tubing into the refrigerator connection, at the back of the refrigerator, as far as possible. While holding the tubing, tighten the fitting. If you are using GE SmartConnect tubing, insert the molded end of the tubing into the refrigerator connection, at the back of the refrigerator, and tighten the compression nut until it is hand tight. Then tighten one additional turn with a wrench. Overtightening may cause leaks. Installation Instructions 67 C Fasten the tubing into the clamp provided to hold it in position. You may need to pry open the clamp. Tubing Clamp 1/4" Compression Nut Ferrule (sleeve) 2 3 Refrigerator Connection 1/4" Tubing SmartConnect Tubing TURN ON THE WATER SUPPLY Turn the water on at the shutoff valve (house water supply) and check for any leaks. PLUG IN THE REFRIGERATOR Before plugging in the refrigerator, make sure the icemaker power switch is set to the O (off) position. See the grounding information attached to the power cord.
- Page 17 and 18: Atrás del refrigerador Se deberá
- Page 19 and 20: Molduras y paneles decorativos. Par
- Page 21 and 22: Cómo insertar los paneles de la pu
- Page 23 and 24: Instrucciones para la instalación
- Page 25 and 26: Instrucciones para la instalación
- Page 27 and 28: Instrucciones para la instalación
- Page 29 and 30: Instrucciones para la instalación
- Page 31 and 32: Instrucciones para la instalación
- Page 33 and 34: CÓMO INSTALAR LA TUBERÍA DEL AGUA
- Page 35 and 36: Antes de solicitar un servicio… S
- Page 37 and 38: Antes de solicitar un servicio… P
- Page 39 and 40: Garantía del Refrigerador. (Para c
- Page 41 and 42: Notas. Importado por MABE COLOMBIA
- Page 43 and 44: DANGER! RISK OF CHILD ENTRAPMENT PR
- Page 45 and 46: About the temperature controls. Per
- Page 47 and 48: About CustomCool . ExpressThaw Ex
- Page 49 and 50: About the water filter. (on some mo
- Page 51 and 52: Press tab and pull shelf forward to
- Page 53 and 54: About the crispers and pans. Not al
- Page 55 and 56: About the ice and water dispenser.
- Page 57 and 58: Behind the Refrigerator Be careful
- Page 59 and 60: Trim kits and decorator panels. For
- Page 61 and 62: Inserting the door panels. Read the
- Page 63 and 64: Installation Refrigerator Instructi
- Page 65 and 66: 4 DISCONNECT THE POWER COUPLING (on
- Page 67: 8 D E REMOVE THE REFRIGERATOR DOOR
- Page 71 and 72: 7 8 REPLACE THE BASE GRILLE Replace
- Page 73 and 74: WHAT YOU WILL NEED (CONT.) NOTE: Th
- Page 75 and 76: Normal operating sounds. Newer refr
- Page 77 and 78: Problem Possible Causes What To Do
- Page 79 and 80: Manufactured for: General Electric
- Page 81 and 82: 4 Tel. sin costo: 01800 90 29 900 I
DIMENSIONS AND SPECIFICATIONS<br />
<strong>Installation</strong> <strong>Instructions</strong><br />
INSTALLING THE REFRIGERATOR<br />
REFRIGERATOR LOCATION<br />
• Do not install the refrigerator where the<br />
temperature will go below 60°F (16°C)<br />
because it will not run often enough to<br />
maintain proper temperatures.<br />
• Do not install the refrigerator where the<br />
temperature will go above 100°F (37°C)<br />
because it will not perform properly.<br />
• Install it on a floor strong enough to<br />
support it fully loaded.<br />
CLEARANCES<br />
Allow the following clearances for ease<br />
of installation, proper air circulation and<br />
plumbing and electrical connections:<br />
23‘ (33” wide),<br />
23‘/25‘ CustomStyle 25‘, 26‘, 27‘, 29‘<br />
Sides 1/8" (4 mm) 1/8" (4 mm)<br />
Top 1" (25 mm) 1" (25 mm)<br />
Back 1/2" (13 mm) 1" (25 mm)<br />
24"(61 cm)<br />
Cabinet<br />
Water Electrical<br />
3/4"(19 mm) Airspace<br />
(1/2"[13 mm] Gap +<br />
1/4"[6 mm] Wall Plates)<br />
25"(63.5 cm)<br />
Countertop<br />
66<br />
DIMENSIONS AND SPECIFICATIONS<br />
(for 23‘ CustomStyle models)<br />
70 1 ⁄4"(178.4 cm)<br />
36"<br />
(91.4 cm)<br />
24"(61 cm)<br />
DIMENSIONS AND SPECIFICATIONS<br />
(for 25‘ CustomStyle models)<br />
72 1 ⁄4"(183.5 cm)*<br />
36"<br />
(91.4 cm)<br />
24"(61 cm)<br />
*72 1 /4" (183.5 cm) required for full adjustment<br />
of mobility wheels. If cabinets installed<br />
above refrigerator have doors that are<br />
flush to the top of the opening for the<br />
refrigerator, then an additional 1/8" may be<br />
required to provide clearance for cabinet<br />
doors to open freely.